Search results

  1. B

    72 c10 350 build

    I’m putting together a 350 for my c10. Im going to lay out what the truck currently has and also what I’d like to do to the motor. I’d like to get some criticism and/or advise. End goal is to have a dependable motor with tons of torque. The truck is not my daily but I’d like for it to be built...
  2. B

    Going to get EBL!! What cam and intake?

    So I’m using my stimulus money to stimulate the truck. Going to just jump both feet in and order the EBL set up. I’m looking for some advise on a cam and intake set up that a novice like me would have a decent shot at getting dialed in. I’m sure there are options that a experienced tuner could...
  3. B

    Cracked manifold. Go shorties or afterburner

    So i found I have a cracked exhaust manifold. I can go flow tech shorties(1 5/8 primaries) with y pipe for $200 or flow tech afterburner with y pipe for $350. Either option will connect to my current 3in pipe into a borla. I’m not running a cat, mine was rattling terribly when I bought the...
  4. B

    Will g80 from 2013 fit my 1994

    Both are 10 bolt. I know the 2013 is 8.6 and my 1995 is 8.5. I’m pretty sure I just need specific bearings but wanted to confirm before pulling out. I also know my axles are 30 spline not sure in the 2013. My friend wrecked his truck and the g80 is free
  5. B

    Looking for intake and cam advice

    Long story short I’m looking to help a friend find a reliable intake and cam combo. He is looking to build a strong efficient daily driver. He recently retired and wanting to get his old truck driving again. He is starting with basically a stock tbi long block swirlports and all. Block is not...
  6. B

    I could use some help with fuel pump issue

    Checked my fuel pressure at the filter and got a steady 10psi. Once the key is turned off it drops back to 0 in less than 30 seconds. The reason I bothered to check is the new plugs look very white which indicates I’m running lean. From what I’ve read 10psi is on the edge of being unacceptable...
  7. B

    BG rod works “old school”

    Can anyone tell me if these will fit? As best as I can tell from reading here the offset will work however I’m not sure about the center hub bore. Right now front suspension is stock and rear dropped 2in. At the most I could see setting it down another 2in front and back. Thinking of running...

Latest posts

Staff online

Members online

... and 31 more.
Total: 1,751 (members: 81, guests: 1,670)

Forum statistics

Threads
64,311
Messages
1,391,135
Members
51,387
Latest member
Yukoncornelius

Share this page

Top