Search results

  1. Tim W

    Brake lights

    I have an issue thats got me stumped... my 94 silverado's brake lights work Intermentally But my third brake light works as it should. I've checked the fuses and all fuses are good and I can hear the relay clicking, In fact I actually have power to the relay that I checked with a test light...
  2. Tim W

    multifunction lever

    Good morning yall, On my 1994 chevy silverado the turn signal lever (multifunction lever) wont lock in the up position but it locks in the down position. This just started today. What could be going on w it? all signals, wipers cruise controls ect work. You just have to hold the lever up to...
  3. Tim W

    Oil leak

    Iv been chasing a few pesky oil leaks on my truck (97 5.7 block thats in a 94 1500) . I solved the majority of them over the few years. 1. I replaced the cork valve cover gaskets with fel pro Rubber gaskets. 2. Relaced the valve covers with a high quality aluminum valve covers from clay smith...
  4. Tim W

    Power steering

    Im not sure this is in the right spot, so if its not, my apologies. I just replaced my steering box with a high dollar Borgeson. My old one was was leaking from everywhere but the lines. After swapping the boxes i now have a line leak from the high pressure line. I went to the parts store and...
  5. Tim W

    5 long years

    Iv been working and building on my truck since 2018. I bought the truck from Arizona, sight unseen and had it shipped over. I will admit, I had a good platform to begin with. The truck has zero rust and was a good driving truck. The truck itself only had a few cosmetic blemishes (macco style...
  6. Tim W

    Used transmission

    So my 4l60e and torque converter are just sitting in my garage. It may or not be bad. It did not to shift at all other than 1st gear and reverse . Come to find out my TPS was completely dead so maybe that's why it wasn't shifting?? Idk. I should have checked that b4 spending the money on a...
  7. Tim W

    Power window motor

    My driver's side power window was slow, now it's dead. I ruled out my switch. I bought a new motor from the parts store but have not put on yet. When I take off the old motor from the Regulator, is that under pressure? Ima try to just drill the rivet out with out removing the entire assembly.
  8. Tim W

    4l60E

    Well, my 4L60E took a dump. I lost all gears except 1st and reverse. This is the second transmission my truck ate. I knew I should have went w the 80. My sniper and Transmission have been fighting each other from day 1 even though my transmission had it very on TPS. As of last week I ordered...
  9. Tim W

    Stock radio

    The radio in my 94 Silverado all of a sudden stopped playing Music on the FM channel. It worked one day then the next it didnt. I can hear "white noise" when I scroll through the stations but no actual music. When I switch to "AM" I can hear the stations but there is still alot of white...
  10. Tim W

    Power steering pump

    Whats a good power steering pump? Mine is leaking from around the shaft seal behind the Pulley. I went to rock auto and they list several different ones for my truck, which is a 94 1500 with a 5.7. Any particular pump that yall recommend?
  11. Tim W

    Collector gaskets

    I'm having my headers coated by Jet Hot coatings. What size collector gaskets do I need? My headers bolted up to my stock Y pipe. I checked Gibson's website but its doesn’t say what size the collector is. Just that it will bolt to stock y pipe
  12. Tim W

    Dyno run

    When my truck went on the dyno she had fresh amsoil and filter. She survived the pulls and tuning. Should I change the oil and filer again?
  13. Tim W

    Spark Plugs

    My truck currently has NGK R plugs in it that need to be replaced due to an upcoming Dyno tune session. Are NGK plugs a better choice than ac Delco? I guess the NGK R plugs are what the guys put in while doing my holley sniper installation. Also would the plug gap be based on my motor being a...
  14. Tim W

    Wheel size

    I'm looking to put America racing outlaw1 wheels on my truck. My setup is currently a 15×8 steel rally wheel. The tires are a copper cobra 275/60 r15. They do not stick out at all which is what I want. I think the wheel has a -12 offset with a 4" back spacing. The tire shop is say the only...
  15. Tim W

    GMC Head lights

    This could be a dumb question but are GMC and Chevrolet headlights and corner marker lights the same for 94?
  16. Tim W

    Intake manifold Gasket

    I am replacing my antique manifold. What is the best gasket to use
  17. Tim W

    JBA or any Long Tube headers

    Does any one have any experience with JBA long tube headers? I want to change out my Gibson shorts. Id like to put them on with as little modifications as possible. Im limited to my options bc I want SS ceramic coated.
  18. Tim W

    USshift trans controller

    I will be installing or attempting to install a trans controller in my 1994 chevy w a 4l60e. The instructions are pretty straight forward. My question is what do you do with the old harness thats still attached to the computer? Do you leave it plugged in and just ziptie it out of the way under...
  19. Tim W

    stand alone

    Question regarding a stand alone controller. My transmission has never been right persay since the day it was built. Its a 4l60E. With that being said please dont get in a debate about 60s vs 80s. An 80 is not in the future and the question is about a stand alone controller. :peace:It was built...
  20. Tim W

    Muffler vs muffler

    does anyone have any real world experience with Borla Atak vs FM super 10s? I currently have True dual 3" exhaust and super 10s. My truck sounds good but I want louder. I dont want exhaust cut outs bc they leak and rattle. I read where borla atak mufflers are louder and sound better than a...
  21. Tim W

    Muffler vs muffler

    does anyone have any real world experience with Borla Atak vs FM super 10s. I currently have True dual 3" exhaust and super 10s. My truck sounds good but I want louder. I dont want exhaust cut outs bc they leak and rattle. I read where borla atak mufflers are louder and sound better than a...
  22. Tim W

    Starter

    whats a good starter that doesnt need shims? Mine on my 94 is about to take a dump. I just want to bolt and go. Thanks fellas
  23. Tim W

    fan shroud

    any one know where i can get a fan shroud for a 94 with a 34" radiator? Iv looked but All i can find are one for the smaller radiators. Any one have one they would sell?
  24. Tim W

    Hood hinges

    im looking at doing something to my hood hinges. I looked at eddie motor sport replacements and man over 600 bucks. They look nice but IMO not worth that. So i figured id have them chrome plated. There's a company here in houston thats does a great job. My question is do yall think the chrome...
  25. Tim W

    Dumb question

    I want to have the lower alternator/ power steering bracket chrome plated. When I remove the screws that hold the bracket to the bock is there going to be any oil come out of the block? This is the bracket i am asking about. Again sorry if this is a dumb question

Latest posts

Members online

... and 14 more.
Total: 1,440 (members: 64, guests: 1,376)

Forum statistics

Threads
64,247
Messages
1,389,804
Members
51,236
Latest member
Old97silver

Share this page

Top