Search results

  1. B

    T-case wiring

    So on my Yukon, it had the Autocrap and swapped it out for a manual 241. Easy enough, 100% bolt it. Hardest part was getting 246 out, it's lil more portly than the 241, but it's out. Since it's manual, pull the magic lever and the front shaft spins, but front doesn't engage. Looking over wiring...
  2. B

    Superlift 8 lug lift kit 5"-7"

    Plans changed again, gonna try to sell this again. It's all new, still in boxes, just opened to start install n take pics. I have new upper control arms with new bushing/BJ, and 2500LD knuckles to run GMT-800 brakes. Just need the lowers ($188 IIRC from Summit), the upper b/j hole will need to...
  3. B

    Early NV4500 bellhousing

    Looking for an early bellhousing for a GM, 92-95. I have an AA bell, and wont work without alot of BS that I don't feel like doing. Plus a 12" clutch might not fit, and don't want to run a smaller one. Will be towing with a bigger big block, so need a bigger clutch!! I have the AA to...
  4. B

    Clutch pedals

    So since I didn't sell or trade the NV4500 i have, and it's already rebuilt, I'm gonna put it in my 99 CCSB. It has an Advanced Adapter's bellhousing, but nothing else. I can get the hydro stuff, but need to use a slave off a 85-91 square Chevy. But getting confused on the pedals, don't see why...
  5. B

    Misfire cylinder #4

    Can't seem to get rid of a misfire in my Yukon. I did full tune up, cap/rotor, plugs n wires. Plugs didn't look bad, but did em anyways. It has the miss at idle/low RPM, but smooths out the higher the RPM. It runs like a ****, so to me doesn't think it's a major issue. I was thinking it could be...
  6. B

    PITA Np246

    I got a good deal on a 99 Yukon that seller claimed had a bad trans. As it turned out, the trans is fine, the t-case was stuck in neutral. I've only have one of these trucks with this case, and even back then I hated it. But I'm trying to keep this a simple build, even tho I don't plan on doing...
  7. B

    Sub box for a crew cab

    Gonna be replacing the entire stereo and speakers in my 99 CCSB. All stock now, and sounds like crap. Already have head unit picked, as well as component speakers for the doors. Not even worth it to replace the 4x6s in the rear posts. I have old school MTX truck boxes that I was gonna put behine...
  8. B

    Aftermarket ECM and factory gauges

    Toying with the idea of going all aftermarket fueling on my 1999 Chevy with the 454. Not sure what system wanna go with, but one that makes more power than the OEM stuff can support. But I want to use the stock gauges. Not sure if the sensors go thru the ECM or not. I know I could use the 0411...
  9. B

    NV4500 4wd

    Getting tired of dealing with auto tranny's. i want to swap a 5-speed into my 99, and the 4500 is bout the only thing strong enough that will bolt in. Must be 96-newer, complete. Be awesome if it was a donor truck, but would need to be close enough. I have cash, and some parts maybe for a...
  10. B

    Superlift 6” lift for K2500/3500 88-98

    Bought this for a truck, sold the truck so don’t need this. It’s brand new in the box, only opened to see the shiny new parts. This is a discontinued kit, i looked n could t find it anywhere online. Should fit 88-98 (2000 OBS GMT400) with 3 bolt idler arm. The older trucks might need to upgrade...
  11. B

    Black 8 lug center caps

    Looking for 2 GMC black center caps, late 90s style that uses the black plastic caps to keep them on. Also looking for 2 dually black caps for the rear, late 90s as well. And a complete set (4) for Chevy, again, black late 90s style. Don't really need the caps, but will take em. Lemme know price...
  12. B

    350 to 454 swap

    I found a posts while searching on my phone, now I can't find on my laptop. I want to potentially swap a 454 into my 99 with the 350. One search result said that didn't swap the wiring, used the stock 350, changed very little. Also even used the 350 ECM/tune till got it flashed. I'm debating...
  13. B

    L21 Vortec 454 worth getting?

    Local junkyard has a 2000 Vortec 454 L21. All forged internals, coils on cylinders, no distributor, not sure on wiring or ECM. Is this worth getting? I'd like to swap the 350 out for this in my 99 crew cab, runs great but alot of truck for not alot of motor. I think I can get the motor for $800...
  14. B

    Tires with cut out flares

    how big a tire can you put on these trucks (k3500) with cutout flares and no lift? I have a new set of flares, but wondered how big a tire will fit. I ran 33s on my old K2500 on an 8" rim, barely rubbed the stock flares. I'm wondering if a 315/70/17 would fit on an H2 rim, but would tuck too...
  15. B

    Ramjet setup

    Got this couple years ago with the intent of putting it on something. Well, it ain't gonna happen. This is used, other lil dirty from sitting on the shelve, there's nothing wrong with it. I think the only thing missing is the distributer and the air filter. This is the MEFI III version, doesn't...
  16. B

    LS wiring harness

    Who has the best price/product for stand alone wiring harness? Don't really feel like pulling one from a junkyard, asshats will cut wires just to pull a alternator or starter. Seems to be there all around $500...
  17. B

    No cruise control

    Trying to figure out why the cruise doesn't work in my 98 hoe. I was told it could be the brake switch, which is a major PITA to replace, it didn't fix it. All fuses are good, everything seems to be fine other than that. Possibly unit is bad?
  18. B

    steering column/pedals

    Toying with the idea of making my 98 Tahoe a 5-speed. Someone told me years ago that the columns and pedals can be year specific, quick search on carpart says they are. Anyone know for sure or what the differences are?
  19. B

    Superchips tuner/programmer

    Buddy has a superchips for the black box trucks, thinking of getting it if it's worth it for my 98 Tahoe. Didn't get a part number, but can't imagine too many options from Superchips for the later GMT400s. I can get it for $200.
  20. B

    Yukon rear door latch

    Is there a difference in latchs over the years?? When I got my 96 Yukon, the driver side cargo door was missing the lower latch. No big deal, I got one when from a 99 I think Tahoe. But it won't fit, the bolt pattern is different. I figured the relatively short span they made they would they...
  21. B

    Lund Windjammer

    Lund is out of business, amazon is out, none on evilbay, anyone have one?? Fits 92-up Blazer, Tahoe, Yukon and Suburban up to 2000. Need one bad for my Tahoe, cant see out the back windows lol.
  22. B

    built 406 or mild 350 w/whipple

    I don't have a build thread or signature or anything like that. I have a 96 4 door lifted Yukon that has 68k with a Whipple supercharger. I bought it dirt cheap, knowing it needed motor/trans. I bought one with 138k, ran friggin' great, and was impressed with what a stock motor would do with the...
  23. B

    LED headlights

    I ordered bunch of LEDs for the interior from superbrigheds.com, noticed they have LED headlight bulbs. Anybody ever use em? How do they work?
  24. B

    Wiring up sub n amp for escalade console

    i just got an escalade center console, complete with sub, amp, and CD changer. I could care less bout the CD changer, but is it worth to wire up the amp/sub? I have an aftermarket head unit, dunno if be easier or not to wire up to that. Anybody have the wire diagram for this?
  25. B

    Tahoe limited ppv gauges

    Not sure what all vehicles had them, but know limited and PPV had them, 120 or 130 mph speedo. Few and far between where I am anymore....

Latest posts

Members online

... and 13 more.
Total: 1,853 (members: 63, guests: 1,790)

Forum statistics

Threads
64,342
Messages
1,391,618
Members
51,453
Latest member
1014Barnes

Share this page

Top