Search results

  1. D

    Death wobble with all new front end.

    I had a tiny bit of death wobble on my 2000 Yukon denali (obs), and then I had a u joint failure, driveshaft fell out on high way, so i redid the u joints and now the death wobble is much worse, only at highway speeds. It has all new front suspension and tie rods pitman and idler are good...
  2. D

    Evo delete without removing pump.

    Is it possible to put in an evo bypass without removing the pump. If it is how do I do it. Otherwise I'll probably just swap the steering speed sensor.
  3. D

    Do I need a new body control module

    Have a 2000 denali (obs) and it has a peculiar problem where the radio often doesnt turn off when the ignition is off even after the door is opened. It will only turn off after the bcm is unplugged and plugged back in. I had replaced the ignition switch thinking that was the problem, but it...
  4. D

    Best way to prep and paint rusty frame.

    So I want to rehabilitate my frame. I have been using one of those abrasive disks that go on y0ur drill and it has been working good. I will attach a picture of the side I have done and the side that hasn't been done. My question is what product should I use once it's all clean to paint...
  5. D

    body lift and budget e-fan conversion

    Will be doing a 3 inch body lift soon on my 2000 Denali, after going through the forums, it seems some people have cooling issues with the regular fan because the radiator is raised with the body and the fan isn't. I assume the best solution is an e fan conversion. id prefer to source as...
  6. D

    4wd actuator broke flush with axle

    when I was doing a diff drop on my truck (2000 Denali), I accidentally broke the 4wd actuator off flush with where it mounts on the front diff in the axle extension thing. Im wondering the best way to fix it. I can buy another one, but im not sure how to remove the part that's inside the axle...
  7. D

    Truck chirps when turning

    I have a 2000 denali. I just got it together enough to road test it and I noticed that it makes a squealing or chirping noise when turning. So I checked the steering fluid and it was low so I added some, this definitely reduced the loudness but the sound is still there. Also sometimes when...
  8. D

    Rear hatch seal part number

    My 2000 Denali is leaking from where the glass hatch meets the roof, does anyone know where I can find the seal, i cant seem to locate the part number on rockauto or amazon. It should be the same as the tahoe and suburban.
  9. D

    replace driver side leaf spring without dropping tank

    Is there any way to remove the forward bolt holding in the leaf spring to the frame without removing the gas tank. The clearance between the frame and the tank seems pretty small. truck is a 2000 Yukon Denali. One of my leafs are broken and I already have new leaf springs ready to go in.
  10. D

    Brake lines from master cylinder to abs module

    Does anyone know what the part number for the lines that go from the master cylinder to the Kelsey hayes abs module are. I cant find them anywhere. Car is a 2000 Yukon Denali if it matters.
  11. D

    Sandwich adapter for tranny cooler.

    I had a filter that would come off and so I took of the adaptor. Didnt come off real easy and so i need new tranny cooler lines, which I ordered, but I am thinking it would be way easier to change the filter each time if I put a sandwich adaptor on one of the straight down adaptors. Has anyone...
  12. D

    Crack in head, can it be reused.

    I pulled the heads of my 2000 Yukon Denali with vortec 5.7 because I accidentally broke an intake bolt in one of the heads and I figured I should pull them both. I have a crack in one of the heads on one of the exhaust valve ports. You can see it in the photo. It's not between the valves or...
  13. D

    Egr tube stuck on intake (vortec 5.7)

    The egr tube nut wouldn't come off my intake when I was doing the gaskets so I cut it off. But I still cant get the damn thing off the manifold. It just wants to round off and deform. I heated it with a heat gun. Tried penetrating lubricant. I even called two machine shops to see if they will...
  14. D

    2000 Yukon Denali misfiring on cylinders 1 and 7.

    I have a 2000 yukon denali with the 5.7 vortec, that my dad stored outside for 5 years, I am trying to get it into running shape. When I first got it, I changed spark plugs and sprayed fogging oil into the cylinders, new battery, had to put in a new starter, checked the fluids, etc. At first it...

Latest posts

Staff online

Members online

... and 9 more.
Total: 1,542 (members: 59, guests: 1,483)

Forum statistics

Threads
64,247
Messages
1,389,769
Members
51,235
Latest member
ggddff

Share this page

Top