Search results

  1. NAST96

    Transfer case seal

    First off: what exactly are you talking about? Your front transfer case is leaking from the rear seal? Are you running a doubler setup? For some reason I seriously doubt it. So let's start by figuring out what component you are talking about. The transfer case sits behind the transmission. Is...
  2. NAST96

    Ford Super Duty wheels on a GMT400?

    You don't have to run wheels that are hub centric. But as far as super duty wheels the lug pattern is different after like 99. It's 8x180 or something and Chevy is obviously 8x6.5. So to answer your question, no probably not, without a spacer that converts it to the Chevy pattern.
  3. NAST96

    4l60e blowing oil out of dip stick??

    The transfer case should have atf in it... Not gear oil... But if you checked it and it was fine, that's besides the point.
  4. NAST96

    Head Gasket vs Intake Gasket

    It's possible and maybe more likely to be just the intake gasket,although I have heard of a handful of head gaskets leaking. If you could get it for $800-$1000 it may be worth getting and tearing into. Only downfall is it has almost 200k on it, and could need a lot more work had it not been...
  5. NAST96

    Black soot, running rich

    Sounds about normal to me. They say anything over 50psi will overcome the poppets. I have heard guys say that you need 60+psi. I have never got that much even after installed a new pump and filter. Mines always about 58psi or so. Sounds like your FPR is good also beings it isn't leaking off...
  6. NAST96

    OBS (Old Blown up ) to NBS (New Bad ass ) Build Thread

    I bet it does, did you use chalk and water to check for leaks when you were done? And did you go with anti-coning rings? I have been looking into a setup like this for my crawler.
  7. NAST96

    Black soot, running rich

    Have you ever considered replacing the coolant temp sensor? Mine ran pig rich and always sounded like it had a misfire, even at idle. Did plugs,wires, cap rotor, MAF, threw all kinds of things at it. Did a little more research and decided to try the coolant temp sensor that goes in the top of...
  8. NAST96

    OBS (Old Blown up ) to NBS (New Bad ass ) Build Thread

    Looks killer man. Where did you get the bead locks from?
  9. NAST96

    8.5" 10 bolt Cross shaft question

    Hello all, I have a few questions for someone with hopefully a little more knowledge than me. A little history first. About 10,000 miles ago I installed a lockright "lunchbox" locker. Fast forward a few years, I found my axle seals leaking and decided it was time to take care of it...
  10. NAST96

    3" BL and 275's

    It also depends on rim size. I have had 285/70/17 and 285/75/17 the 70's measure out to 32.4 brand new. The 75's measure out to a tad over 34". My uncle has 305 70 17 km2s and they are shorter than my 285 70 17 and a bit wider. But I'm guessing everyone here is talking 16's...... Edit...
  11. NAST96

    Richmond Powertrax Lock-Right

    I have one also. and a lockright in my other 96.
  12. NAST96

    ebay police tahoe cluster

    Thats kinda neat. Havent seen one like that before. Good find.
  13. NAST96

    chevy stepside

    If it was 2,500 i would buy it. The body doesnt look too bad imo. Not sure if im diggin the stripes or not?..
  14. NAST96

    Solid Axle Swaps

    Agreed^^
  15. NAST96

    As of now

    Looks good man. always liked your truck!
  16. NAST96

    Crew cab dually

    Didnt know they made rockstars in 16's.
  17. NAST96

    Fabtech Long Travel.

    Truck specs would help.
  18. NAST96

    Southern Pride's Official Build Thread

    How did you get that NBS overhead console to work? i got one just like it but cant figure out how to make it work because the lights and cubby stick out further than the outer part of the console. ANy pics of install? Did you cut into your headliner?
  19. NAST96

    AC leaking in cab.

    you guys are all on the right path. The drain line would be the first thing to check. As for the dripping alot of water.. on both my 96's the pour water when running on high. I have redone the a/c system in both with new compressors accumulators, orifice tube, lines, ect ect..... I do own an...
  20. NAST96

    Wheels, wheels, wheels....

    Ok guys i have a 96 gmc k1500 4x4.. I'm looking to clear some 35 12.50 15's on a 3" body lift and a little crank (little bit of cali) Im wondering if a -30 offset would make me rub to bad. Its about 3.75" of backspace. I would love to run a postive or even a 0 offset but noone makes...
  21. NAST96

    2001 Tahoe on 22s trade for obs

    Off subject but you can only buy/sell so many vehicles? GLWS! Looks clean man!
  22. NAST96

    Fog lights wired

    Agreed^^ check the ground.. If all is good there get a new switch! Any pics of them in action and what brand are they?
  23. NAST96

    Quick question about t-case shifter

    Looks good. I did a similar thing and put a T handle on mine. Looks good man!
  24. NAST96

    Quick question about t-case shifter

    Thanks man. i really appriciated the quick response! I will give it a shot and see what happens.
Top