Search results

  1. Ironjet

    Help identifying lift kit

    Thanks I’m guessing it was early 90’s as well
  2. Ironjet

    Help identifying lift kit

    Does anyone recognize this lift? As far as I know it was installed when the truck was new in 1995 It looks to have been painted red originally
  3. Ironjet

    Help. Chasing a hesitation issue

    I saw it mentioned earlier, check your fuel pressure. I had a pump that was putting out only 4 psi. the truck ran but not well I chased every sensor and replaced all ignition parts only to get no where Also, a tbi gasket set with new regulator is only about $25 cheap and easy to replace
  4. Ironjet

    NV 4500 2wd to 4x4 conversion

    Hole saw and a long drill bit for the clutch master, Jigsaw for the floor, although the impression seemed a touch too big for the trim ring and boot
  5. Ironjet

    Engine stalls when heat is on and You put in Reverse 1995 Silverado

    Be sure to check battery terminals and connectors
  6. Ironjet

    95 5 speed swap, almost done what else do I need?

    I bought the ecm from rock auto, the chip I bought on eBay, however the 4l60e computer has different connectors than the manual computer. That’s what I get for not doing enough research I did end up putting the new egr valve on , and between that and a new fuel filter it runs fine on the...
  7. Ironjet

    Auto to Manual PCM

    I left the neutral safety switch plugged in and turned the selector to be in park, and then just secured it up. This way if I want to put the auto back in it’s all ready to go. I also had to change to connector for the transfer case My 95, the computer for an auto has different plugs and...
  8. Ironjet

    95 5 speed swap, almost done what else do I need?

    Hey all, I’ve been in the middle of swapping my 4l60e for a nv3500. (95, 305. 4x4) I used a 98 5 speed with the internal slave. So far I’ve put about 6K miles on it , this has been with the ecm from the auto still installed . It runs ok , but it’s not great. I’ve got the egr and knock...
  9. Ironjet

    Manual trans bouncing in gear

    I have a 95 that i was/ am experiencing something similar. I changed my coolant temp sensor, MAP sensor and my TPS , and it has cleared up quite a bit, but it’s still there. My next step is to change the fuel filter Right after I cleaned my k&n air filter I started having this issue ...
Top