Search results

  1. P

    Hey Guys I Need Help Quick

    well good you found the problem,. think people might have been mis led when u said you put on a rebuilt tbi,. Now the diaphram is bad,. Anyway i'll probably catch some flak but i shim my spring really tight,. with a nut or something,. i've no idea truthfully what it makes the fuel pressure but...
  2. P

    Hey Guys I Need Help Quick

    Don't chase after the timing chain,. unless its worn a hole in the cover it'll run fine sbc pretty bullet proof,. use a strong LED light to look at injector spray I personally think u may have an ecm problem,. after the evm works with a deteriorating ground for a couple of years,. it can...
  3. P

    1997 chevy k1500 P0300

    What are your iac counts like? the vortec distributors can get worn and flop around a little at idle,. and check to see if your throttle blades are clean,.
  4. P

    Factory console lid

    Not really sure what you mean or how?
  5. P

    Factory console lid

    Thankyou,. never thought of a slipover,.
  6. P

    Factory console lid

    I swapped a power chair into my old 95,. i,m not sure what year it came from (98?) it has a writing pad lid on it that flips up,. the padding around it is non existent, so i would like to re pad it,.. Can anyone tell me how to take the lid apart? it looks like the hinge pin is sealed in there...
  7. P

    1997 2-door Tahoe 4x4 LT1 swap

    The a/c compressor fits without notching? i have a couple of good running low mile lt1's and 1 brand new oem crate engine, just iron head motors,. I have a 95 truck,. i would like to put a gen 2 in the truck, they are really torquey even at 350cid.
  8. P

    1997 Sierra diesel - battery leads came off while driving - no electrics - what's fried?

    i'm not that smart but if you have busted battery terminal connections loose enough to jump off,. you need new cable clamps,. OBVIOUSLY you have a bad connection AT the battery)s)
  9. P

    Tbi rough cold starts

    you might examine your ect plug pigtail,. if its got green monster in it, it will read erroneously. If your iac is not moving enough it won't have high idle cold but will have enough to run warm. You may also have a small tbi to intake gasket leak,. Tbi is sensitive to iat too, and lastly the...
  10. P

    Piece of aluminum chipped off my Tbi injector casting and got sucked down my throttle body

    There's quite a bit to unpack here,. how did it chip off? ( tell the truth ) you were running it at full throttle till it flooded,.? i'm not sure i understand that i've had numerous big chev motors over the last 45 yrs or so,. i don't know how much fuel you'd have to put thru it to make it...
  11. P

    Help, seize when cranking on cold starts

    I agree with viking dude,. poor ground,. the connection warms up makes better contact you are good to go,. check your ground connection is not going to an aluminum anything,. get it on to shiny clean piece of cast block or head,. if that didn't work for me i'd buy new battery cables
  12. P

    LEAN on both banks

    i was under the impression that a vac leak will cause the O2's to dump fuel to compensate,. Have you run the truck in speed density?
  13. P

    94 4.3 CPI to 92 4.3 TBI

    As i stated cost effective,. performance was not part of the answer
  14. P

    94 4.3 CPI to 92 4.3 TBI

    easiest cost effective for you is pull your heads and intake put them on the 94 short block.
  15. P

    gmt to K2 swap

    no rich,. the ecm will run motor and trans just fine,and a/c and cruise . the 95 cab is pretty easy to work with,. I reprogram my mercedes vehicles, where parts need to be coded to the sam modules to integrate,. GM is not that complicated. the 1.4 electronics will run the 2 litre with a...
  16. P

    gmt to K2 swap

    My 2014 is rotting away,. i like the truck the way it drives and stops,. has the LV3 and 6l80,. which i really like for power and really good economy. So we are thinking of putting the 95 ecsb onto the 14 frame. I searched but haven't found this done yet. Any thoughts from some of the senior...
  17. P

    Help me Wheels Spacer fitment on my c2500 suburban 1996

    i used the narrow nuts to hold spacer to truck,. and factory wheel nuts to hold the wheel on
  18. P

    Help me Wheels Spacer fitment on my c2500 suburban 1996

    you don't have to go "full" lock ,.
  19. P

    Help me Wheels Spacer fitment on my c2500 suburban 1996

    i would think that a plow truck puts more load on than a daily driver,. in and out of reverse so much,. i have done 3 sets of spacers,. the thing learnt most important, is to really degrease the truck studs absolutely dry,. then use the red loctite,. and torque the spacers in 2 goes.
  20. P

    1995 7.4 454 glowing exaust manifolds.

    The exhaust is glowing because its too lean,. and or retarded timing,.add a couple more degrees to the timing and stretch the tbi fuel pressure regulator spring What an F'd up thread with all these non relevant posts about RPO codes,.and music stuff
  21. P

    !995 cheyenne add cruise control,.

    So i got the 1995 column today,. but it does not have the same wiring as i got out of a 93 (duh) ,. up to 94 the multifunction lever is simple twist it and pull and it has wiring and a small spade type plug,. which simply plugs into the wiring harness i got,. the module and cable look the...
  22. P

    !995 cheyenne add cruise control,.

    thanks JohnGAAA1 you ARE awesome!
  23. P

    !995 cheyenne add cruise control,.

    If i get a 1995 tilt steering column with cruise control,.column comes with a key,.. will it bolt right in >? or do i need to put my ignition tumbler in it? so i gues the question is does a cheyenne have a vats? I already have the cruise module and cable, and wiring harness, but the wrong...
  24. P

    1995 cruise control shenanigans

    i gathered up all the cruise control from a 94 truck,. but my 95 has a different turn signal stalk and harness,. Will a later morel multifunction lever and harness work from a 98? they seem like a lot or work to change that harness to add a cruise button,. its like the truck has old and new...
Top