Search results

  1. M

    Code 41 coming up

    Hello all, Finally got rid of the monies gauges on my 90 5.7 step side truck and now I’m able to get codes out of the truck via blink code. That being said I’m looking at code 41 cam sensor circuit fault, igntion control circuit fault and tried to do a bit of digging into it have not really...
  2. M

    88-91 to 92-94 cluster upgrade

    Hello all, I am wanting to swap out my moonies the cluster itself is starting to fail, having over 500,000km on it I figure it’s time for replacement. I have 2 gauges from the 92-94 sitting in my shop and have connectors, I still have the drac to remove but that is minor. Right now I’m...
  3. M

    90 350 service engine soon flashing while running

    Hello all, Little but stumped right now with my truck, I recently installed a freshened up 350 has 150 compression across the board, has all new sensors and plugs wires etc, Recently set my timing with the wire unplugged to 0 or very close to it, shut down the truck plugged the wire back in...
  4. M

    90 5.7l confused on a single wire connector

    Hello there, I have my stepside that I’ve ripped all apart and starting to go back together redoing a lot the wiring, found this single wire connector looks like a knock sensor but that’s already connected and done it comes up near the Ac and intake out of the main harness will include a...
  5. M

    Torsion tubes going to lower control arms

    Hello everyone I'm working away trying to get my truck frame ready for a treatment of por-15, and I have beaten the living sh't out of the lower control arm and air hammered at the key I haven't even budged an inch. I have it soaking in a bath of pro film(wool wax spray) anyone have any extra...
  6. M

    Shop Heat

    I have a smaller two car garage right now that I work out of I have a 240 heater trying to keep it warm in there during the winter but it's expensive to keep running what other ways are you guys heating your shops with, if I had room id go to a wood stove but not enough room right now Sent...
  7. M

    1990 GMC K1500 5.7 Cam Questions

    Hello all, I have my stepside all ripped apart right now getting the frame ready for POR15 bath and im just wondering while i have my 350 TBI out of it and i was going to do head gaskets; intake gasket pan gaskets; timing set; check the lower bearings while i was at it I figured while i was at...
  8. M

    Restore of a rcss

    So it’s finally warmed up enough outside that I’m able to start working on the truck, I’ve picked up a few parts during the winter like a low km 350 to go into the truck and a few other odds and ends. Well anyways I was able to get something done I was able to get the rear bumper hitch and box...
  9. M

    Newish guy from Manitoba Canada

    Hello all, From central Manitoba working at a dealership shop and service manager. Had many different styles of the 400’s over the years but I’ve been searching for a while now for my first truck which was a 90 rcsb step side. Well I finally found one after 15 years of being without it. So here...
Top