Search results

  1. delta_p

    Power steering pump drive shaft seal

    I think my power steering pump is leaking at the rear reservoir seals or someplace. I'd like to remove the pump take it apart and put a full seal kit in it. what is the best way to remove the drive shaft seal? The service manual says to use shim stock protect around the shaft and chissel out the...
  2. delta_p

    Oil leak, but not where I thought the leak was

    I pulled my transmission thinking the crank shaft seal was leaking. But when I got to it it looked like it is dry and it is the oil pan gasket? It is a little wet up top the engine too but I can't tell if it is from this. I swear the seal looks good, I attached some photos. Would you even...
  3. delta_p

    Rolling back the 4l60E for rear seal access

    I am in the process of moving my transmission on '96 so that I can install a new rear crankshaft seal. So far so good. I didn't drop the exhaust, I just slid the flex cover to the side and removed the starter and set to the side and have plenty of room to get wrenches and impact on the torque...
  4. delta_p

    Wanting a drop on the 1996 C1500

    I've about decided to 2/4 drop my 1996 C1500. I've read a lot that folks say it's not enough of a drop, but I think anything lower I won't be happy. I just want a little bit lower and run my BFG's on 15's. I've been messing around with photo shopping and i like the look of middle pic (estimated...
  5. delta_p

    Linex Bedliner

    I finally did something to the truck I have been wanting to do for a long time. I took it in and had Linex sprayed on the bed. I have been using the same plastic bedliner for 23 yrs. on the '96 and it worked great but....time for a change. I am happy with how the Linex turned out and makes this...
  6. delta_p

    wheels and tires

    Thought i would post a pic of the new rear wheels on my '96. Ultra 50's. 275's on 15x8's with a -19mm offset. This truck is not my daily driver and i got some 235's on 15x7's with a -6mm for the front but have not mounted yet. For anyone interested the 2WD 15x7's have basically a zero offset...
Top