Search results

  1. GaryCCR

    1996 C1500 5.3/4L60 ECAB

    Sold
  2. GaryCCR

    1996 C1500 5.3/4L60 ECAB

    Selling my 1996 Chevy C1500 92k miles.. I've had the truck since 2003. It is a project but does runs good, drives, and stops. Truck sat for a long time. I paid a guy to swap in a 5.3l out of a 2002 avalanche, with a 4l60e. All new seals in the motor, ls6 springs. .500/.500 lift ls1 cam. Has the...
  3. GaryCCR

    Mileage on 5.7 vortec

    What year is your truck? How many miles? What trans? 2 or 4wd? If it was a tbi 4wd truck with 300k I'd say that's not too awful. How's you air filter?
  4. GaryCCR

    6.0 into 2000 k2500

    Nice build. I'm jelly of that a/c setup. I had to get custom hoses made and a new compressor. Looks right on the front of that LS motor.
  5. GaryCCR

    Blower fan speed problem

    Sounds like the blower motor resistor.
  6. GaryCCR

    94 chevy k1500 5.3 LS swap questions

    In my truck I used a aux battery tray and put the battery on the Dr side like the gmt800, like my motor came from. If your motor is a 04 it's new so you'll need the gas pedal and module. Custom ac lines. I used a bulldog brand cold air intake for a h3 fits the truck like it was made for it...
  7. GaryCCR

    gear shift position indicator problem

    It gets the signal from the neutral safety switch
  8. GaryCCR

    ls swap water temp & fuel guage problem

    You have to tap the head to get your old temp sensor to fit. I'm using a 98-02 camaro v6 temp sensor in mine.
  9. GaryCCR

    SOLD Aztec Needles

    I'll take them if they are available. You do PayPal?
  10. GaryCCR

    Amp problem

    You need; power, ground, remote and a good fuse. If it's not on it may need repair. I agree, use a multimeter to confirm 12v.
  11. GaryCCR

    99 ccsb don't know what to do

    I agree. I love lowered trucks. It sounds different and I like that. If you're not going of road I wouldn't lift it.
  12. GaryCCR

    90ss 454 4l80e swap?

    I may be wrong but a 90 would have a 700r4. If you want to use the 4l80 you'll have to use a aftermarket computer controller to have it shift. What year is the truck?
  13. GaryCCR

    Anyone got interior door handle bezels?

    I bought a new pair from Amazon. I think they were like $9 each. Updated, I found the page https://www.amazon.com/gp/aw/d/B00BITIOR8/ref=mp_s_a_1_1?ie=UTF8&qid=1495751714&sr=8-1&pi=AC_SX236_SY340_FMwebp_QL65&keywords=door+handle+tahoe+1996+trim&dpPl=1&dpID=31u+-GldAvL&ref=plSrch
  14. GaryCCR

    Yo what's up obs peeps!

    Nice truck, very tasteful improvements.
  15. GaryCCR

    What is the control box attached to the master cylinder for?

    I have a 96, mine doesn't have it. I think that's for your ABS.
  16. GaryCCR

    I wanna hear your exhaust set up!

    I have true duals, with 2.5" pipe. I bought a "thunderbolt" muffler from eBay. It's stainless, two in and two out, straight through with a cross over. It sounds amazing, deep baritone rumble. I had flowmisers, but it sounds way better. Best part, it was $60!!! I have a 5.3l, but wanted to chime...
  17. GaryCCR

    GMT800 MC Swap Gone Wrong, It Sucks Bad

    If you pump the pedal, does it hold pressure? What year/model is your truck? Did you bleed the ABS module?
  18. GaryCCR

    GMT800 MC Swap Gone Wrong, It Sucks Bad

    This might sound silly but, did you bleed the lines? If you pump the pedal, does it hold pressure? It could be a bad MC or air in the lines. What year/model is your truck?
  19. GaryCCR

    Do I need a new radiator?

    I think it was NAPA, they sell a flush for the trans cooler, in an aerosol can. I would just replace the radiator. If it's original it's over twenty years old, and not that expensive. I just replaced my radiator in my '96 and I got it for about $50 online, money well spent.
  20. GaryCCR

    Newbie with an OBS from South Louisiana

    Welcome from Jefferson Parish. I happen to love the 5.3l in my '96 but to each his own.
  21. GaryCCR

    K2500 clicks but won't start

    Is your battery hot?
  22. GaryCCR

    BS oreilly experience

    I avoid O'Reilly auto whenever possible. They told me once they couldn't warranty tie rod ends because I'd replaced them too often... Even though they were sold with a lifetime warranty. I tried to plead my case, I was told they only will replace parts under lifetime warranty if there defective...
  23. GaryCCR

    LS Swapping my '95 Silverado (5.3 LM7)

    Nice work. If you're getting it bored, you can have it bored to a 5.7 and use ls1 pistons. They have the same stroke, some call it a ironblock ls1. When I get into my 5.3 that's my plan. Keep us updated, gl.
  24. GaryCCR

    Tbi to vortec. Cant find answers

    If you just swapped long blocks wouldnt it be way cheaper to put a 4 barrel 96-99 intake manifold and run and adapter/spacer on top for the TB? This manifold, Professional Products Cyclone Vortec Intake Manifolds 52007, is only $140, compared to $450!!! I only payed $500 for my complete running...
  25. GaryCCR

    1991 K2500 SAS death wobble

    This may be a silly question, but have the wheels/tires been balanced?
Top