Search results

  1. danman6677

    Changed intake gaskets now doggy.

    OK I had a timing light ready to go and remebered about the wire but I looked high and low and this truck DOES NOT have a brown wire. can you show me pics of where it is? The wires under the relay on the passenger side cowl are all red/orange or pink. And the blower motor is all bundled up tight.
  2. danman6677

    Changed intake gaskets now doggy.

    I recently changed the intake gaskets on my 94 silverado and now it is doggy like when I press the gas it is slow to accelerate and mildly hesitant. I was wondering about the timing but I read it is electronically controlled. My older 88 had the brown wire I disconnected and set the timing but...
  3. danman6677

    K1500 vs K3500

    I was looking at balljoints and noticed the part numbers for the 1 tons is different than the 1/2 tons, why?
  4. danman6677

    transfer case not engaging

    My problem is with 4HI, Ive never shifted it into 4LO.
  5. danman6677

    transfer case not engaging

    what is the wires going into the axle above the actuator
  6. danman6677

    transfer case not engaging

    I shift into 4wd and the lights come on but when I am in Drive and start to move the light will go out and I am in 2wd, is this the Actuator or wiring?
  7. danman6677

    2wd and 4wd front end interchange

    I want to know what steering pieces are interchangable between a 1991 C1500 and a 1994 K1500.
  8. danman6677

    1988-1995 oil cooler line fittings

    I was wondering if the Quick Connect fitings are better than OEM? Is there any other alternatives like using a NPT fitting and rubber hose?
  9. danman6677

    antifreeze overflow overflowing

    I read that a bad rad cap will cause this more than anything else
  10. danman6677

    antifreeze overflow overflowing

    Well my family and i were on our way to town when the temp gauge was maxed and steam was pouring out , I opened the hood and found the coolant overflow...boilin over and the rad dry. What bad luck all this and it is -41 here, luckily I managed to drain the antifreeze from the overflow into a cup...
  11. danman6677

    Question about the 3rd door on GMTs

    Was the 3rd door standard or an option and what years was it available?
  12. danman6677

    Real or Built??

    I found this but wasnt sure about it. http://www.ebrandon.ca/ItemView.aspx?item_id=982786
  13. danman6677

    engine stumble/miss

    I swapped the CTS and the IAC from my smooth running 94 and it started fine but it will stall only in gear after 30 seconds or so. I noticed it will lurch when it is put in drive.
  14. danman6677

    engine stumble/miss

    I went for a 2 hour trip and when i was at at tim hortons and stopped to make my order it stalled out it still runs rough too. I checked my TPS and the voltage is good. Would the CTS do this it doesnt have any black ness in the tailpipe?
  15. danman6677

    engine stumble/miss

    It has no codes, and i just replaced the coil and wires...nothing changed. I checked all the sensors, cleaned the egr and the IAC. And sprayed carb cleaner around the throttlebody but no vacuum leaks. The only thing left would be the timing and a proper fuel pressure test.
  16. danman6677

    engine stumble/miss

    The trucks wires were next on my list. I slowly pushed the throttle open and can feel the miss through the rpms. By the way the truck is a 1992 c1500 350 engine.
  17. danman6677

    engine stumble/miss

    OK, Ive replaced the plugs,cap, rotor, rebuilt the fuel pressure regulator and the fuel filter replaced finally injectors rebuilt, the engine was rebuilt in 09 but is clean burning. Im trying to figure out if its fuel or ignition related before throwing more money at it. Ive tried changing the...
  18. danman6677

    bouncy rear

    no overloads, it has 4 leaves and i just went out and looked and the passenger side topspring near the front spring mount is not as curved as the driver side.
  19. danman6677

    What'd yall pay for your trucks?

    The officer had given a ticket for a safety certification since the vehicle was still running after he removed the key, it was paper thin.
  20. danman6677

    bouncy rear

    The truck used to tow a 5th wheel before I bought it, and the shocks are not worn out (10,000kms)and they are correct for this truck. The truck is a shortbox stepside z71 on propane.Would the propane tank cause this being at the front of the bed and full? The feeling is more juttering but not...
  21. danman6677

    bouncy rear

    My 1994 z71 used to tow a 5th wheel but I added new Monroe monotube shocks but i notice the rear will bounce on uneven pavement, would the springs be needing replacement? The truck does sit level.
  22. danman6677

    What'd yall pay for your trucks?

    Couldnt pay fast enough... Hey, I got one of the best deals ever on a GMT400, I bought it in bc for $1000! Rebuilt engine,trans and new gm G80 all with 99,000kms when I bought it the chassis has 270,000 but couldnt tell. Found a set of 3, '09 Avalanche rims from the Hyundai (closed GM dealer)...
  23. danman6677

    Air conditioning

    Wasnt sure if this goes here but, my 1994 k1500 with a 350. I hit the button for the AC but the compressor doesnt turn, first I checked the fuse but its good, whats next?
  24. danman6677

    3rd brake light

    $150!!! from LMC, Ill keep mine with burnt lens and all
  25. danman6677

    3rd brake light

    Hey, Im looking for a new 3rd brake light for my 94, besides the wreckers and the dealers anybody know where to get a factory one? id go with the LEDs but dont like that they arent sealed the same.

Latest posts

Members online

Total: 1,585 (members: 48, guests: 1,537)

Forum statistics

Threads
64,247
Messages
1,389,737
Members
51,235
Latest member
ggddff

Share this page

Top