Search results

  1. inthechateau

    Passenger door fitment for 3DR cab

    I need to replace my passenger door. Will a standard cab or extended cab door fit? I have the 3rd door on RH passenger side, just not sure if regular or extended cab door will work.
  2. inthechateau

    The Stupid Electronics Questions Thread

    I finally get to hook up a CB radio in my 98 K1500. I've had CB's in a lot of different vehicles over the years but never had on that would stumble when you key the mike to transmit. I have good grounds all around, antenna cable not close to the ECM or nothing. I'm stumped on this one.
  3. inthechateau

    98 K1500 with 3" body lift.

    Had fun installing the lift last week. Looks pretty good I think.
  4. inthechateau

    planning on painting my truck myself.... need advise plz....

    I see no one has piped in yet so I'll give you MHO. Great Goose you got a job to do there. I've never taken one apart to paint before but not wrong for doing it that way, you may have a few matching issues not shooting all panels at once though. Venting vapors to the atmosphere is an EPA issue...
  5. inthechateau

    Replacement Bump Stops?

    I ended up using the generic from big box parts store, they fit fine and do the job.
  6. inthechateau

    How Much Can YOU Haul IN 1/2 Ton???

    My 89 K20 with 3500 landing gear under it. Dual wheels on full floating axle last time I hauled with it came off the scales at 16,500. Had a load of mulch on the truck and what was supposed to be 2 yards of stone on the trailer. I think the loader did me a favor with extra stone. Was happy to...
  7. inthechateau

    1998 Sierra Front Bump Stops

    Bought a set of universals from big box store A A auto parts and they fit fine. $13.00 a piece
  8. inthechateau

    Frame interchange question

    We started a 97 K1500 frame swap, but project is not going forward. Extended cab 8 ft bed. So we now have a good frame with no use. If you hear of anyone interested let me know by PM. Located in MD.
  9. inthechateau

    5.7 ECM and full underhood harness

    Came out of a 97 Tahoe but I won't be using it. Best offer. Also have a clean 5.7 block, fresh cam bearings and freeze plugs. Located in Maryland. Tim PM me if interested.
  10. inthechateau

    Clutch engages at the floor.

    Do yo have all free play until that point in pedal? Have someone push the pedal while you watch the slave actuate. If pedal travels all the way down until the slave starts to move you have leaking/bad clutch master cylinder. Is fluid up to level?
  11. inthechateau

    98 K1500 hard shift 1 to 2 when hot

    It finally popped the 1870 DTC. Ordered a rebuilt VB from Ken Partin Transmissions http://kenpartintransmissionparts.com/ . Very nice guy to talk to and great price ($159.00) See how it works out, He says it will give me firmer TC hold too. We;ll see
  12. inthechateau

    1995 silverado, shifts fine no tc lockup though

    On my 98 I found the brake switch was causing issue. Fine cold but as it warmed up there was just enough problem with switch contacts it would keep TCC from occurring.
  13. inthechateau

    98 K1500 hard shift 1 to 2 when hot

    No DTC yet, just started to act up the other day after a long hot day drive. Been pulling a lot of trailers lately. Going to check brake switch first for TC lock up issue, replaced that switch when I put truck on the road last yer. Aftermarket junk as usual. Pull pan after I get my weekly mowing...
  14. inthechateau

    98 K1500 hard shift 1 to 2 when hot

    Had event today never experienced with my 98 Silverado. Has 5.0 with 4L60 with 130K on the clock. After driving about 30 or so miles noticed it starting to shift hard into 2nd from a stop. Rest of shift cycles seem fine. Cooled down and took it out and shift is fine but I do not feel the...
  15. inthechateau

    AC system help 98 silverado

    So I finally found my AC leak. The switch on the back of the AC compressor is the culprit. Is this the cycling switch or hi pressure ? Not sure what I need to be looking for. It is the 1136582 Delphi compressor. Any help would be appreciated.
  16. inthechateau

    98 Silverado 5.0 hitting P0420 DTC on consistant basis

    Got tired of the CEL on, no responses or hints here so I took the jump, pulled the Y pipe, and after several fitment installed and tac welds finally go tit right. Welded in a new Flowmaster universal CAT. OEM Cat was all busted up, half full of oil and coolant deposits. Cleaned the O2 sensors...
  17. inthechateau

    Stock tape player

    Will be pulling stocker out of my 98 silverado this weekend if you are still looking. Tape player works as does the rest of the radio functions. Send me an offer and shipping from 21001
  18. inthechateau

    98 Silverado 5.0 hitting P0420 DTC on consistant basis

    Need ideas on replacing the CAT. Any hints?
  19. inthechateau

    98 Silverado 5.0 hitting P0420 DTC on consistant basis

    So a few months after dropping new 5.0 into my 98 Silverado it started chugging out a P0420 DTC code. history is the old engine when I bought truck had blown head gaskets, found several cracks in the heads actually so I put a crate engine in it. After starting the new engine the exhaust took...
  20. inthechateau

    TBI Edlebrock performer intake on CL

    http://baltimore.craigslist.org/pts/4928126830.html Needs to be cleaned but PM me for shipping quote if interested. Tim
  21. inthechateau

    96 Tahoe 5.7 4x4 2400.00 b/o

    Bumping this thing up, lowered price to 2200 for forum members, tags expire end of this month so need to sell. Make an offer. Truck is completely drivable and can go anyplace.
  22. inthechateau

    1994 c3500

    Where are you located?
  23. inthechateau

    96 Tahoe 5.7 4x4 2400.00 b/o

    It may not go with tahoe, end up on my Z71 most likely.
  24. inthechateau

    1997 5.7 Vortec won't start.

    Had no start on my Tahoe, turned out to be rotor button burned through, melted tab that contacts the dist cap electrode.
Top