Search results

  1. E

    Egr block

    Don't quote me but I think it may be 1.5 x M18.
  2. E

    TPI CONVERSION for Vortec 383 97 Tahoe.

    I do believe he's using vortec heads. He never gives any specifics, kind of using the site for a bill board.
  3. E

    TPI CONVERSION for Vortec 383 97 Tahoe.

    What are you using for the lower intake manifold, Scoggins Dicky? What are you doing to address the fuel vapor system?
  4. E

    Any?? SBC 400

    Where did you get your engine adapter? Archies used to make them.
  5. E

    G80 CARRIER QUESTIONS

    You should find out the carrier "break" (differential carrier deck height) before doing gears, it does make a difference. From what I see you should be good to go. As far as the shims go you may get lucky, then again you may not. It's always good practice to check the tooth contact pattern...
  6. E

    Let's see your shops/garages

    Are you having pads poured for a lift or is the floor thick enough without doing that? I have a concrete floor that's 4-5 inches thick but I'm under the impression that lifts require thicker support pads than that. Will you have a lift?
  7. E

    o2 sensor question!!

    Those are some excellent links.
  8. E

    EFI Swap - been doing my research, am I missing something?

    I suggested the TPI because it has a usable rpm range for a daily driver and I think it looks great. That's just my own personal opinion. A lot of the choice depends on how you want to use the truck. If it's going to be a daily driver with occasional towing I'd base my decision on those...
  9. E

    EFI Swap - been doing my research, am I missing something?

    You could always go old school and use the TPI system.
  10. E

    400 TPI CONVERSION for 1998 3500

    I'm pretty computer illiterate. I typed in A&A Performance under Groups? When the results popped up there was a pic of a bunch of GN7's that popped up. The fella is from Mississippi.
  11. E

    400 TPI CONVERSION for 1998 3500

    I went to FB, found it.
  12. E

    What electric fan setup?

    I've seen LT1 fan setups in the recycling yards that look like they'd move plenty of air. As a matter of fact I've also read that the LT1 Roadmaster used a mechanical as a secondary fan setup for towing applications.
  13. E

    HP Tuners

    I'm curious. Is there a repository that you use with these tuners? I'd like to be able to load a segment for a manual transmission into a black box (or 0411)that is set up for an automatic trans so it doesn't throw a zillion codes is why I ask.
  14. E

    NV3500 breaking point?

    Not trying to hijack your thread but I'm curious how the full size NV3500 compares to the one in the V6. I'm under the impression that there's a difference in 1st gear, but how about the others? I have the V6 model and they are hard to come by in the 4x4 version, well 2wd also and would like...
  15. E

    Full fuel line replacement! What would you do?

    Did you re-use your original fittings with the nylon line?
  16. E

    5speed swap

    How about the ECM? Won't it throw a bunch of codes since it's looking for inputs from the A/T?
  17. E

    5 speed, need smoother shifting

    I don't suppose any of you fellas with the 98 models could send a pic of the white label on the bottom of your black ECM for me that shows the service number and the other info? I'm trying to find one at my local salvage yards and would like to make sure it's the correct one before buying it.
  18. E

    1998 ecm

    I'd also like to know, who on here can modify opertating systems? I have a 0411 that has a 5.7? auto Savannah van operating system in it at the moment. I don't think any vans came with the 5 speed did they??? Anyone on here do this kind of work?
  19. E

    1998 ecm

    All I have to do with the black box is stick it in, change a few wires around and do a relearn procedure and I'll be golden. The 0411 can come later after it's running.
  20. E

    1998 ecm

    Hi guys, I need some assistance. I'm wanting to find a picture of the ECM for a 1998 4x4 truck, a Silverado with the 5.7 and manual transmission. I need to see the white label tag that has the Service number and the other information on the bottom side of the black box. I'm putting together a...
  21. E

    Any advantage to vortec heads on a TBI 350?

    Aren't the Vortec heads supposed to be more prone to cracking also?
  22. E

    Steering Wheel Swap

    A good condition leather wrapped wheel will run you approximately 100.00 just for the wheel. You don't necessarily have to swap clock springs either. When I swapped my wheel for my 98 I got a later wheel with the small air bag. I kept my original clock spring. You can change the end of the...
  23. E

    My wifes 2016 Ford Explorer is rusting already...

    I feel ya. I'd be pissed too!
  24. E

    Need a small starter for 153tooth flywheel

    You could try a Caprice starter that was installed on the 5.7 cars. They were for 153 tooth flex plates and were a reduction starter also.
  25. E

    Air Bag Compressor

    Get yourself one of the plastic battery boxes and use that. You can mount it where ever you need that way.

Latest posts

Members online

... and 11 more.
Total: 1,892 (members: 61, guests: 1,831)

Forum statistics

Threads
64,326
Messages
1,391,404
Members
51,430
Latest member
Noel11

Share this page

Top