Parttimer101
Newbie
So I recently got someone else's project for a good price. The biggest issue I'm running into is wiring. They swapped the OG motor to a gen IV 454 with a built NV3500 trans. If anyone can point me to schematics, guides, or how to properly wire this engine swap it would be greatly appreciated.
A few of the issues are:
-spliced wires all over the place, in cab and in engine bay
-none of the gauges worked, and the two that did (speedo and gas gauge), were unreliable at best
-harnesses disconnected in trans area, cab area, and in engine bay
I was able to drive it fine, but just want to undo all the mess and do it right. Not interested in swapping anything out (trans, engine).
A few of the issues are:
-spliced wires all over the place, in cab and in engine bay
-none of the gauges worked, and the two that did (speedo and gas gauge), were unreliable at best
-harnesses disconnected in trans area, cab area, and in engine bay
I was able to drive it fine, but just want to undo all the mess and do it right. Not interested in swapping anything out (trans, engine).