SM465 to NV4500
- Thread starter Michael Y
- Start date
-
- Tags
- nv4500 swap
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
You will need the bellhousing from a 1996+ NV4500 and you will need to swap out your clutch master cyl and slave cyl to the newer internal slave.
Not sure about the crossmember but if you need to move it, all you have to do is drill a few holes. Not too difficult.
However, measure the overall length of the two to make sure your driveshaft is the correct length.
Not sure about the crossmember but if you need to move it, all you have to do is drill a few holes. Not too difficult.
However, measure the overall length of the two to make sure your driveshaft is the correct length.
My truck is 2wd. It's not going to be in the mud. I do not have the flywheel dust shield. Can I go without it or will it hurt anything?
I wouldn't run without one.
Staff online
-
df2x44L60E Destroyer -
kennythewelderOfficially Retired, B31-3 (6-G) certified welder.
Members online
- df2x4
- Feedfc
- 96OneTon
- movietvet
- jimdaug
- Marine1979
- orange57
- Supercharged111
- torhne
- Hipster
- strikk
- KagamineFan
- shablagoo_gabagool
- yevgenievich
- Curtis21
- kennythewelder
- jacknewt
- Ekays
- scott2093
- JPVortex
- Drunkcanuk
- L31MaxExpress
- BNielsen
- Caman96
- Moofus02
- Danimal08
- Nephrodoc
- Char
- X1PZ_
- Blue91
- 90sprobs
- Orpedcrow
- maddux1037
- Justin e
- SNCTMPL
- rhammond
- sethdm02
- IndexOf0
- Zoomdot849
- NCBrochacho
- Salty K1500
- bigcreepo
- aaronb
- SL1CKR1CK
- MartilloTejano69
- fancyTBI
- ludwickb
- Javlin42
- John Moore
- Chase33