Custom Dash / Accessories - 3D Printed

mars2878 said:

Dont remember if it was mentioned or not or if you can curves w/ a 3D printer or not, but what about a console door?

I hear alot of guys complain about broken hinges.

If possible w/ reinforced /thicker hinges.

You must be registered for see images attach

Click to expand...

383mazda said:

A popular mod is to swap these HVAC knobs out for a newer set from an express van:

You must be registered for see images attach

They're a direct swap, however, the headlight knob requires some dremel modding because the newer knob doesn't fit the "selector rod":

You must be registered for see images attach

Perhaps you could print a new shaft / rod that has a male end to fit the new style knob?

Click to expand...

mars2878 said:

Would this work for you?
Got it off of Amazon.

You must be registered for see images attach

Click to expand...

mars2878 said:

Would this work for you?
Got it off of Amazon.

You must be registered for see images attach

Click to expand...

PlayingWithTBI said:

I can't find any replacement vents for this truck. That's why I asked, oh well. Does anyone have a source?

Click to expand...

arrg said:

LMC truck has them.

Click to expand...

Wildblue19 said:

I've been designing the cover to use one similar to these. Can you get me a measurement of the overall length of the USB port body, from the face plate to the back, as well as the threaded section's diameter? From what I measured, the OE cigarette lighters have 1.575" of clearance from the face to the inside of the door.

Click to expand...

Wildblue19 said:

I've been designing the cover to use one similar to these. Can you get me a measurement of the overall length of the USB port body, from the face plate to the back, as well as the threaded section's diameter? From what I measured, the OE cigarette trays have 1.575" of clearance from the face to the inside of the door.

Click to expand...