My 99 Tahoe 4wd build..

Well I had to send back thise 4.88's I got a deal on a few eeeks back turns out they were for a 10.5" so now I'm stuck waiting on a refund so I can order the correct gears. I did a little more profiling work on the diff cover then plumbed up my brake calipers and started building my ride height valve linkage. I also got a steal the other day on a full set of factory 2001-up tahoe 3rd row seat brackets and trim vovers picked it all up at a local u-pullit for $10. Got my girls out there to get comfy in the third row so i could measure and layout where they brackets are going to go snd loomes like I'll have quite A bit of cargo room left with my 13 and 14 year old girls in the back seat sitting comfortably i still have 18" from the bottom of the seat to the back doors

Well after a crazy weekend I finally got my 14 holt ready to go under my Tahoe

Well Ingot the 14 bolt installed under the Tahoe then Inkinda got a little sidetracked with a power beadroller I've been building to make my dual fan shroud and a couple other small items for myTahoe but its more for the extensive metal fab work I've fmgot to so to my Twin turbo big block 69 Chevelle I had to store in my trailer until I can finish the Tahoe

Well after alot of stuff got in the way I'm finally back on the Tahoe build hard.... Just changed out the entire front suspension and steering components with all Proforged components and upgraded the hid assembles to some heavyduty lifetime warranty Mevotech hubs I got from rockauto. Also installed a 2" lift block kit cleaned and bedlined the back half of the chassis and started running the fuel system. I recently got my hands on a nice set of leather front seats with the jump seat from a 2002 2500hd that are going in after I modify the trans tunnel. I pulled and sold the remaned 4l60e and picked up a 95 4l80e 4wd core trans from a guy I know and have bought everything to build a kittler 4l80e that can take anything I can throw at it. I also gathered up the 32 spline input chaft to install in my 241c transfer case and 4l80e transfer case adapter to built everything up. I alresdy repinned and added the proper wires for the additional fwd steep sensor for the 4l80e and preprogrammed my 0411 pcm for the 02 express 5.7w/4l80e trans cal. I also built a new engine management harness to match my new engine configuration.

I'm also waiting on my powdercoater to get bsck in town to get my table coated for my 36" beadroller I'm building as well

Any updates?

chevyracer8262 said:

Put my interior back together to see how everything looked so far..

You must be registered for see images attach

You must be registered for see images attach

Click to expand...

That’s nice work clean and functional very nice workmanship!!

Very nice work all around sir! I’m on edge of my seat waiting for your next updates !! Lol

Finally got a chance to get back to work on my tahoe

Updates