ertlecar
Newbie
Nice choice of mufflers. I used to have a Magnaflow mufflers in my old F-150.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I spent alot of time figuring where i could cut and what had to be reshaped. The inner braces i complete cut out at the spot welds and used the orginal 97 in place of the 02 roof. The 02 roof fit right into the drip rail of the 97 and i used the rubber seal that the o2 uses on the top of the doors. Very quiet No wind noise.Almost wish there was a write up on that roof swap. It looks like the outer edges of the new roof is the old roof grafted in?
It would be easier to do the knuckle swap. I cut alot off of the factory knuckle and machine a flat face for the caddi caliper to bolt to. I did the gmt800 master and a 2000 rear axle swap with the rear disk. Brakes are absolutely amazing. Stops extremely well. With a trailer it stops better than factory. I still have abs on it too.I would like to see a picture of how the front brake spacer is made and how much work is required for that job, or if it is easier to ream the ball joint hole and swap the whole spindle off a 99?