2000 GMC K2500 resto/cummins

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

df2x4

4L60E Destroyer
Staff member
Super Moderator
Joined
Mar 1, 2012
Messages
11,203
Reaction score
12,809
Location
Missouri
I like the black bumpers. Gives some nice contrast to the white in combination with your grille center section, headlights, mirrors, flares, etc.
 
Joined
May 10, 2012
Messages
340
Reaction score
436
Location
NJ
I like the black bumpers. Gives some nice contrast to the white in combination with your grille center section, headlights, mirrors, flares, etc.
I concur. Gonna have to paint the front bumper filler and that little piece between the filler and fender black I think.
 
Joined
May 10, 2012
Messages
340
Reaction score
436
Location
NJ
Got er registered this morning, so all further road driving will be legal and whatnot.
Replaced the rear bumper and loaded the diesel tune onto the trans controller.drives so much better now
You must be registered for see images attach

You must be registered for see images attach
 
Joined
May 10, 2012
Messages
340
Reaction score
436
Location
NJ
in the video, is your speedometer not working? i can't figure out why it wouldn't.
I just hooked up the speedo wire the other day, now it works, just says I'm doing 80-100 mph whenever I'm moving.still have to adjust the speedo output signal ratio it seems...
I've been trying to get a rpm signal for the trans controller for the past few days, this dodge ckp is a huge pos or just defective out of the box...
You must be registered for see images attach
 

BlastingBat998

I'm Awesome
Joined
Mar 12, 2019
Messages
122
Reaction score
156
Location
Preston, Idaho
i don't remember where I've seen it but i have seen people use transmission rams for the speedo like you said, but they said it was "an easy thing to do" don't quote me on this, just going off my memory here.
 

letitsnow

I'm Awesome
Joined
May 5, 2018
Messages
1,684
Reaction score
2,462
Location
MN
If I did that swap, I would do whatever I could to replace any dodge parts with anything aftermarket.
 
Joined
May 10, 2012
Messages
340
Reaction score
436
Location
NJ
If I did that swap, I would do whatever I could to replace any dodge parts with anything aftermarket.

I concur. Was trying to use the dodge one because it fits so nicely in the bracket that came with the fluidamper...got frustrated and ordered this last night. have to make up a new bracket for this one, but it is very not dodge
You must be registered for see images attach
 
Joined
May 10, 2012
Messages
340
Reaction score
436
Location
NJ
i don't remember where I've seen it but i have seen people use transmission rams for the speedo like you said, but they said it was "an easy thing to do" don't quote me on this, just going off my memory here.

I adjusted the speedo output signal today.looked better, wasn't doing 80 when I reversed up the driveway. no legit road test until I get the trans solenoids replaced though. They arrived today so I'm going to hopefully get that done tomorrow, weather permitting.
You must be registered for see images attach
 
Top