Crazydavez28
I'm Awesome
Well, I threw a battery in it and put the wires back on. Seems to have a timing issue BC it started then ran terrible for 10 seconds with a horrific knock. I could not get it to run any more than starting and 1 second sputtering after the initial running.
I'm guessing the kid was starting to remove the engine BC he broke the heater hose manifold going to the rear heat. Also the distributor was loose so I might have to reset it a couple teeth... Strangest thing was that the fuel pump relay was missing very odd to remove that even as a prank.
My goal at the moment is to get it running long enough to get it off the trailer and test all the 4wd stuff. Then I plan on parking it under my cherry picker in the shop. Gonna drain oil and stick the scope in the drain hole.
Do these have the windage tray? I haven't torn one down in years.
If it isn't 4-bolt I'll just build up a long block before yanking it. If it is 4-bolt I'll yank it and build that block if it looks good.
I'm guessing the kid was starting to remove the engine BC he broke the heater hose manifold going to the rear heat. Also the distributor was loose so I might have to reset it a couple teeth... Strangest thing was that the fuel pump relay was missing very odd to remove that even as a prank.
My goal at the moment is to get it running long enough to get it off the trailer and test all the 4wd stuff. Then I plan on parking it under my cherry picker in the shop. Gonna drain oil and stick the scope in the drain hole.
Do these have the windage tray? I haven't torn one down in years.
If it isn't 4-bolt I'll just build up a long block before yanking it. If it is 4-bolt I'll yank it and build that block if it looks good.