Had a little accident and dropped the door while changing the hinge pins so now my power windows stopped working. Switch was yanked out of the socket and the clip was pulled off the motor.
Original motor is working.
Tested the fuse and theyre good.
Power and ground at the connections.
Did test the voltage and it is at 10.2V and the blue and brown connector.
The yellow hot wire is at 12V but then turns into the orange and leads into the switch and that orange wire looks fine.
Followed the wires back and can see no tears, ( did fix the ground wire though).
I am stuck right now, not sure if its something to do with the convinience center or why the complete voltage is not getting there. I have diagrams for the wiring but
Any help is appreciated
Original motor is working.
Tested the fuse and theyre good.
Power and ground at the connections.
Did test the voltage and it is at 10.2V and the blue and brown connector.
The yellow hot wire is at 12V but then turns into the orange and leads into the switch and that orange wire looks fine.
Followed the wires back and can see no tears, ( did fix the ground wire though).
I am stuck right now, not sure if its something to do with the convinience center or why the complete voltage is not getting there. I have diagrams for the wiring but
Any help is appreciated
