Recent content by v0nzipper

  1. v0nzipper

    No Spark

    This ground is part of the engine harness (not a typical ground strap). It needs to be checked from the bottom of the motor by the crank pulley.
  2. v0nzipper

    No Spark

    Check all the grounds of the motor. I missed one near the crankshaft pulley while doing heads
  3. v0nzipper

    Power mirror switch wiring

    For anyone who loses all function at once and the fuse is still good, take a look at the harness connector in the driver side kick panel (next to the parking brake). To get access, remove the sill cover and the kick panel. All of the power door function connections are pushed in a cubby in this...
  4. v0nzipper

    Post pics of your truck with newer style factory oem wheels

    2020 Silverado wheels with 265/65/18 BFG KO2s
  5. v0nzipper

    GMT400 projector retrofitting

    Finished product. Not 100% happy with the cutoff, but it will need to do for now. Kydex was used to shroud the projectors. The total depth of the projector/bulb/igniter is about 1/3" away from the battery. You can run dual batteries and still have room.
  6. v0nzipper

    GMT400 projector retrofitting

    Getting closer
  7. v0nzipper

    GMT400 projector retrofitting

    Yes, rad support needed to be trimmed in a similar pattern as the square "bucket" mount. The passenger side is awfully close to (basically touching) the battery once the bulb and igniter are installed. This is still a work in progress. I bought some Kydex (moldable hard plastic) to form a...
  8. v0nzipper

    GMT400 projector retrofitting

    Going the route the OP with an OEM+ look and polished fluted plastic lenses.
  9. v0nzipper

    The Center Console Thread

    2004-2010 Toyota Sienna center console in a Tahoe. Front lower left will need to be trimmed for second row foot vent duct. Rear will need to be elevated about three inches for best fitment. Unit is easily removable too. Grey color is very close to OEM. The plastic texture is slightly different...
  10. v0nzipper

    GMT400 projector retrofitting

    Part 2:
  11. v0nzipper

    GMT400 projector retrofitting

    I am starting a similar project. I've retrofitted a few cars before and cannot live with halogen any longer. Rig in question is a 1999 Tahoe bought as a COVID project with a bad intake coolant leak. Ended up having "while you're in there" syndrome and did the heads/gaskets as well. I've had a...
Top