I didn't know that about the factory service manuals.
I mean I just had to swap the condenser, I didn't even think to look inside the tube for an orifice tube because I forgot about the orifice tube. My plan of action was to install a new condenser, and that's what I did. Why would I ask a...
Thanks a ton for your message above. I forgot to reply when I read it, so my apologies. You were right, I put the orifice in and that was the issue. I did end up pulling vac for 8 hours and leaving it sit overnight. My dad has a Robinaire machine so I just used that. I just charged it today and...
I FINALLY got mine done. Was just going back through this thread and seen yours above. I TOTALLY forgot to transfer the screen over. How bad is that? This truck literally sees a few trips out hauling kayaks in the spring-fall, and plowing snow in the winter.
Thank you for this. I was about mentally done with the whole job by the time I got to that point so it was my laziness and just not knowing lol. I will order one and install it and hope that's the issue. I appreciate it!
Edited to ask if you know if I'd be better off with the red or white one...
I feel like I need to start this by saying the only knowledge I have on A/C systems is from what I've figured out along the way of fixing issues on my vehicles. I'm going to try to put as much info here that I can about this issue. Also, to preface this story, the A/C blew ice cold before the...
You know.. at the risk of sounding like an idiot when I first posted, I thought this could be converter related. ONLY because ever since the trans was rebuilt, it has had almost like a hesitation off the go. Like it just doesn't move like it should until 2000-2500 RPM. It's so weird because I...
My dad has a 1997 K2500 5.7/80E, uses it mainly as a plow truck but takes really good care of it, it's his pride and joy. It has had an issue for this and last winter where you'll just be driving it and it will shift out of overdrive into 3rd. It seems like there is nothing obvious causing this...
Thank you! I'm hoping that gasket is in good health. i just ordered a 16x12x1" piece of foam from Amazon so I am hoping that is big enough. We have a chance of getting snow on Friday night which is when I will be getting all of these parts so me getting this done is going to be cutting it close...
I honestly can't thank you all enough for your input on this. Below is what I'm ordering. Am I missing anything?
Question on the heater core though. I've never done one or even seen it back there with no dash. What's the best way to drain it enough where it doesn't leak all over the place? Or...
That's a good point you make. I ran through enough piles of wet snow for sure. This truck sure does do everything I ask of it without complaining or acting up. I'm hoping this was the cause. It just seems like it'd be really tough to get water up in there but I guess if I'm running over 1'...
I was out for around 15 hours plowing last night. Noticed about 8 hours in that the back brakes would lock up with even the slightest application of the brake pedal, as well as squeal just before I came to a stop but only in reverse. It didn't do it all the time, but I'd notice when I was...
Thank you both a ton for this info. I was actually asking about replacing the mode door due to the common air coming out of every vent issue on a Facebook group last year but got zero replies.
I did actually get it back into the hole when I was out in the parking lot but it came right back out...