THX 95burban. Yeah, good gaps and tracks straight with no abnormal tire wear. The rust looks worse in the pics...really solid. She lived life in Florida until I brought her to PA in 2015....poor girl started rusting right away :)
I know the rear of the truck was hit when owned by the previous owner.....I took down the spare and really see how bad it is. Lower frame is buckled and looks like someone welded a plate(s) to make it straight (take up the gap) and installed the hitch. Can someone post what it should look...
My 2 cents: I thought TRW ball joints would be good parts but not so. Upper and lower ball joint boots cracked and leaking grease after a few years of only weekend driving. I bought NOS GM joints on Ebay to replace them all. Moog problem solver control arm bushings are cracked on the...
Update: I found some clips at a yard. They are installed from behind the trim and most wrecking yard ones were rusted. Kind of too late now because I attached the trim.
I did find part numbers: GM - 15607139 (disc.); Auveco - 18105 (disc.); Car-pak - 93-7147 (disc.).
I installed new GM door trim on my '97 K2500 and noticed the emblem tabs are a lot smaller than the trim hole. Is there a clip that goes in the holes? I was thinking of just gluing the tabs + using two-sided tape.
Hi all, I replaced the TPS since I got an intermittent TPS code (can't rem. what it was) and it had 179,000 miles on it.
Now my idle is 2200 rpm in Park. Battery was disconnected for 40 min. and then ran it until warm (195 read on scan tool) but I still get the high idle. Everything is...
What is the correct orientation for the shaft: is the slip joint closer to the diff or transfer case. On my old 1992 GMC, it was on the diff side but this truck had it on the transfer case side.
Thanks,
Mark
I have the same issue on my 1997 60/40 power seat. I bought the seat fix on Ebay but that is only for bucket seats for OBS. I can't find any play. Anyone fix this issue?
Thanks,
Mark