Recent content by Trucker1

  1. T

    5.7 vortec long crank

    Just had same problem with my 98 Tahoe and it ended up being the spider injector. Installed new updated spider injector and my Tahoe starts instantly.
  2. T

    Grinding noise after 6 inch zone lift install.

    Noise was coming from rear output shaft bearing in transfer case. Thanks for.the help.
  3. T

    Grinding noise after 6 inch zone lift install.

    Yes I agree sounds like pinion bearing so I disassemble rear diff and installed new bearings. Did not change noise at all. Noise is only there when coasting .
  4. T

    Grinding noise after 6 inch zone lift install.

    What could I use besides tapered blocks? I did have my rear drive made to proper lift length but still have noise.
  5. T

    Grinding noise after 6 inch zone lift install.

    Having a new driveshaft made now, so no drive shaft going to front axle. I am thinking I might be a bearing going down in transfer case.
  6. T

    Grinding noise after 6 inch zone lift install.

    Yes lift blocks are tapered towards the front. Thinner side of block towards the front.
  7. T

    Grinding noise after 6 inch zone lift install.

    Installed a 6 inch zone lift on my 98 2 door tahoe with autotrac and I am getting a grinding noise when I am decelerating. Almost sounds like a worn pinion bearing but have checked and replaced bearings in rear axle with no change in the noise. Did not have this noise until I installed the lift.
  8. T

    Lower control arm bushing problems

    Went and got different new parts and it worked perfectly. Thanks
  9. T

    Lower control arm bushing problems

    Thinking I might have the wrong part, just went and pressed in old bushing and it's a lot tighter then the new part.
  10. T

    Lower control arm bushing problems

    Pressed the old ones out with ball joint press,.
  11. T

    Lower control arm bushing problems

    Rebuilding the front suspension on my 98 2 door Tahoe 4x4, I have removed lower control arm bushing and having trouble getting new bushing to stay pressed in. I can press them in and when I move control arms around in garage the bushing come out.
See more

Latest posts

Members online

Total: 890 (members: 19, guests: 871)

Forum statistics

Threads
64,242
Messages
1,389,564
Members
51,219
Latest member
1989Bowtie

Share this page

Top