in the same boat. Line is twisted, not closed off though just slightly crimped. Would cutting off the dryer save me from having to remove the evaporator?
really not happy with this situation.
bringing back a thread from the dead
a truck i just acquired has a DJM lowering control arm (2") and a 2" lowering spring. Which comes in their 4/6 kit.
would a 3 inch lowering spring work to replace the 2" for a 5" drop?
or would it open up a can of worms?
hey guys i have a 1995 c1500 with the blue interior. 26D is the RPO code. Im trying to get new carpet. Do you happen to know if the acc navy blue is one in the same?
that measurement was from the hub to the fender.
ill check the height on the springs tomorrow when i go to finish the swap but im pretty sure they were around the same height. I emailed djm, they said i seem to have the right springs, grey hammered, and right part no.
its possible it didn't...
question.... i removed the mcg 2" drop spring and replaced it with a 3" djm spring. the 3" spring dropped it a total of a quarter of an inch compared to the mcg. how long until it fully settles do you guys think? or is there something wrong.....