I just replaced my pcv hose because of the same reasons. I cut into the plastic pipe oops. I picked up some 4 pack of pcv hose ends from advance auto. They were marked for fords. I used the coupling hose part and the plumbing p trap hose for the end. I had to cut down the factory plastic hose to...
I know its cheaper to replace just the motor but its way easier to replace the whole assembly. Plus mostly all the wheels i have seen on the regulators have wear marks or grooves on them and should be replaced
These dont work to well with stranded wire which is the majority of vehicle wiring. I say invest in a weatherpack kit and crimper and make oe quality connections
Just the drivers seat is power with the switch in the front of the seat not the side (that's the foam prob you talking about). I pulled the switch and checked the contacts they are tight and get battery voltage at the terminals when each switch is pressed. Maybe the foam still bothers the front...
So I installed some buckets from a mid 90s burb in my 93 Sierra and they are power. I wired everything up and they work fine. Front and back only work with no one in the seat. Thought it was my fat ass so I tried my 100 pound wife and no luck. Is there anything I can rebuild or make better. I...
So I took the cluster out and had voltage at the connection. Verified all bulbs were good and ohmed the circuit. Ohmed open. Under all the bulbs the printed circuit board was effed up. Tried cleaning but didn't work. Got another cluster and took it apart so my miles were correct. Put back in and...