sntrym's latest activity
-
sntrym replied to the thread Shaking rear end.I've had this exact issue with a couple different trucks due to out of round drums or the balance weight falling off. If the drums were... -
Yes, plug it in. That probably won’t improve as time goes on.
-
sntrym replied to the thread Tbi Issue Idle In Between Cold/Hot.Did you have the EGR and AIR pump tuned out of the ECM when you removed them?
-
sntrym replied to the thread turns to the left more then turns to the right.The pitman arm is keyed. It's nearly impossible to get them on a tooth off. Nearly. I would check the arm alignment and remove the...
-
sntrym replied to the thread SBC Engine build.You won't be able to do it, for long anyway, with that block. The 1/2 ton TBI blocks were 2 bolt mains and generally are good up to...
-
sntrym replied to the thread 350 TBI Boggs and surges under load.That's your VSSB. It does speed conversion from the VSS for the speedometer. More info here...
-
sntrym replied to the thread 350 TBI Boggs and surges under load.Which temp sender did you check? There are two - one in the head that goes to the gauge and one in the intake that goes to the ECM.
-
well new wires are in, routing is pretty terrible but its not going to hit the headers or anything hot, so good enough for now. 5 & 7...
-
Yeah definitely the wires, no night test needed. Just looked at the one next to the tbi unit and its ripped in multiple spots.
Staff online
-
kennythewelderOfficially Retired, B31-3 (6-G) certified welder.