Recent content by Redneckgeriatric

  1. Redneckgeriatric

    Low buck TBI truck Cams

    mellings cam. lots of folks still copy mellings.
  2. Redneckgeriatric

    Low buck TBI truck Cams

    you said you were not even going to consider any cams other than comp cams. therefore, i offer no advice. another teeny bopper want a be youtube expert.
  3. Redneckgeriatric

    Valve Seals!

    more than what? if you lubricate "more", what will become of the additional oil? it will destroy the guide and allow more lubrication which destroys more. again, cast guides are the way of the dinosaur. a good thing you can do is contact AV&V. they are in canada and got their act together on all...
  4. Redneckgeriatric

    Torque converter bolts

    may be best for you to trailer it to a shop. if you have engine ready to pull, except mount bolts, it should be really cheap and will (should) insure no damage to transmission or converter, or even engine and other.... figure an hour labor to have the engine sitting on the trailer. dont try to...
  5. Redneckgeriatric

    Spring time

    that looks great!
  6. Redneckgeriatric

    Valve Seals!

    really? what is installed spring height/ bind height/ installed and over the nose pressures? where on the roller is the valve stem locating as you turn the cam? maybe this vortec head is immune to valve problems, if so, the aftermarket is selling tons of parts designed to correct the issues...
  7. Redneckgeriatric

    Valve Seals!

    i have installed them on a bunch of engines that spun a lot of rpm and pushed head temps. not an issue, what is the supposed reason not to run them on exhaust side? im curious.
  8. Redneckgeriatric

    Looking for help on 88-94 cassette deck repair

    it was made in detroit?
  9. Redneckgeriatric

    Amsoil Engine Flush? Should I Do It?

    lol you are right! these trucks are not! they are however, $2000 under engineered money suckers! rest of your post is right too!
  10. Redneckgeriatric

    Where's the oil coming from?

    reckon what would happen if we did use the old style gaskets? slower warmup? poor mpg? curious!
  11. Redneckgeriatric

    Torque converter bolts

    pull the motor with the converter attached. then you can get em out.
  12. Redneckgeriatric

    Valve Seals!

    you would have cut the guide for the seals at the same time you cut the head for the valves and springs. there is really nothing extra to do as you were doing the setup for the other components anyway. im guessing the recipe you followed is one of those "it'll work" deals. valve geometry...
  13. Redneckgeriatric

    Engine stalls when heat is on and You put in Reverse 1995 Silverado

    use a volt meter at the cigar lighter and watch for voltage drop when you shift to reverse. first with key on, engine off, then with engine running. also wacth for engine jumping as you put her in gear, testing for broken motor mount which could affect grounds.
  14. Redneckgeriatric

    Valve Seals!

    why WASTE MONEY ON A PANHEAD?
Top