Recent content by Klassen

  1. K

    What is this connector for?

    You don't know what your talking about. The alternator needs connection to positive battery terminal and 1 switched 12v reference with a resistor. I don't see how giving the alternator exactly what's required is half assing anything.
  2. K

    What is this connector for?

    Simple question. What is the connector for? All other information is irrelevant. It was never plugged into anything on my truck
  3. K

    What is this connector for?

    It's a 96 c1500.
  4. K

    What is this connector for?

    I'm running a Terminator x so there is no correct wire already there.
  5. K

    What is this connector for?

    Does anyone know what this connector is for with the brown wire? I tested it with my multimeter and it's switched 12v which is what I'm looking for to wire my LS swap alternator.
  6. K

    Looking for advice on ABS delete and disk conversion

    I've installed the 14" revelator kit and the NBS master cylinder. I'm thinking about using this Willwood proportioning valve. Is there anything else that would be required to tie this all in? I've read about possibly needing residual valves and so on but I am not sure if this would be...
  7. K

    4L60 to T56 wiring

    I ditched the 4L60 for a T56 and now I have to wire it up. I have figured out the reverse lights and now I am trying to figure out the clutch safety switch. Is anyone able to point me in the right direction on how to wire it? It's a 1996 if that helps.
  8. K

    1998 Chevy 1500 instrument cluster pinout diagram

    Did you find the pinout? Im looking for the same thing and couldn't find it in the service manuals
  9. K

    Clutch Assembly options

    Thanks for the input. I'll definitely be following your thread
  10. K

    Clutch Assembly options

    I've been looking high and low for a clutch pedal assembly that fits a 96. Are there any other options people have had success with? I'm swapping in a t56 to what was originally an auto.
  11. K

    Gmt400 parts

    Looking for a clutch pedal assembly for 96+
  12. K

    Is this normal?

    Notice how the driver side cab mount locations (shown in red) have a cup at the forward mount (Top) and an additional plate on the rear mount (bottom). The passenger side mount locations (shown in blue) do not have the cup or the plate. Is this normal or am I missing parts?
  13. K

    Looking for fuel pump suggestions

    Any other suggestions?
  14. K

    Looking for fuel pump suggestions

    From the research I've done I thought 340lph wouldn't cut it for 650whp forced induction
  15. K

    Looking for fuel pump suggestions

    I'm currently doing a frame up build on a 96 rcsb and I'm the point where I need to start figuring out the fuel system. I have a LQ4 that will be getting a single turbo setup and I'm aiming for 650whp. Should I get a fuel cell and run an external pump or use a stock tank with an intank pump...
See more

Latest posts

Members online

... and 19 more.
Total: 1,845 (members: 69, guests: 1,776)

Forum statistics

Threads
64,325
Messages
1,391,378
Members
51,429
Latest member
Chopitup

Share this page

Top