Recent content by Kbirdjr

K
Memory steering

I’ll be interested to know if the power steering pump helps. I’m fighting this same issue o. My son’s ‘98. It hasn’t been lowered but we did replace the control arms with Moog loaded control arms so new ball joints and bushings. We did pitman arm, idler arm, and tie rods at the same time, all...
- Kbirdjr
- Post #60
- May 24, 2020
- Forum: Lowered and Bagged Suspension
K
7.4L to 8.1 Swap?

Hey, sorry to dig up an old thread BT that’s what goggle does for us. How did this swap turn out? I did the same swap on my ‘99 K2500 last fall and still have a few unresolved issues.
- Kbirdjr
- Post #11
- May 25, 2019
- Forum: 96+ Vortec Performance + Computer Swaps
K
1999 NP241C wiring

Can't figure out how to edit my original post so updating here. I have the transmission wiring figured out but I still can't figure out the transfer case wiring. I removed the harness that plugs into the transfer case hi/low switch (3 wires) and the actuator on the front axle (4 wires). There...
- Kbirdjr
- Post #2
- Nov 18, 2018
- Forum: Transfer Cases
K
1999 NP241C wiring

I have a 1999 K2500 (OBS) that I recently swaped an 8.1L i to. The engine came out of a 2001 Silverado (NBS). I retained the 4L80E/NP241C that was already in my truck. I was fortunate enough (I think) to located a wiring harness from a 2001 C3500 (OBS) which of course was 2wd. Everything plugs...
- Kbirdjr
- Thread
- Nov 9, 2018
- Replies: 1
- Forum: Transfer Cases
K
1999 K2500 transmission wiring to 2001 C3500 harness (all GMT400)

I have a 1999 K2500 (OBS) that had a tired 454 in it. I recently acquired an 8.1L out of a 2001 Silverado (NBS). The donor truck was 2WD and had the Allison transmission. I did not get the transmission because my truck is 4wd and I have read what a PITA it is to put an Allison in one of these...
- Kbirdjr
- Thread
- Nov 6, 2018
- Replies: 0
- Forum: Transmissions