Recent content by JSlezak83

  1. JSlezak83

    Acquiring Arteb Brazil GMT400 headlight reflectors

    I’d be will to sit on a waitlist.
  2. JSlezak83

    How to: Install DIC in gmt400 overhead console

    I stuck my sensor behind the cluster somewhere and grabbed a dash support that was grounded. My thought was it would measure interior temp. Turns outs that sensor needs to be in airflow. Pretty sure it’s adjusted with VSS, so mine doesn’t read close to accurately. I grabbed a smaller GMT800...
  3. JSlezak83

    My K1500 DD Tow Pig

    **** I must have missed the bus.
  4. JSlezak83

    My K1500 DD Tow Pig

    You got a line on those Brazilian lights? From what I’ve read it’s nothing but a pain in the balls.
  5. JSlezak83

    Bought a CC Dually 454 Whipple

    Factory service manual. Set of 4 Volumes. Got it off eBay a year or two ago.
  6. JSlezak83

    Battery problem

    Last year my battery would die within about 3 days. I did the voltmeter test and never saw over .040A draw. Got tired over screwing within dead batteries and this was my solution: Harbor Freight 4A battery tender with a 7 Pin trailer connector. This time of year the truck might sit for months...
  7. JSlezak83

    Bought a CC Dually 454 Whipple

    Photo dump for your column harness. I never realized how much **** was going on in there.
  8. JSlezak83

    Bought a CC Dually 454 Whipple

    Ugh that blows. I got excited for a min thinking I might reseal my just starting to weep booster, but **** that. I’m due for another power steering flush this spring. I’m sure the stuff that came out two years ago was the original fluid, and my god was it disgusting.
  9. JSlezak83

    Bought a CC Dually 454 Whipple

    Went AWOL for a while, so I’m only just seeing this. I’ll see what I can dig up when I get home from work this afternoon.
  10. JSlezak83

    2000 Crew Cab Dually “Waylon”

    So the TPS I robbed from the LQ4 sitting in my Blazer seems to have 90% improved the stumbling issue I was getting once hot. I may just pull the trigger on a new one. I noticed the truck generally seems to drive a little better too I guess wonky throttle data will do that. The front drivers...
  11. JSlezak83

    2000 Crew Cab Dually “Waylon”

    Time to knock the dust off this thread. Summer has been flying by. It’s been jam packed with **** postponed from COVID last year. I haven’t had a ton of time to do things to the truck. I put a pair of Bilsteins in the back at a campground back in July and oh my what an improvement. I replaced...
  12. JSlezak83

    Interesting manifold temp sensor data

    Stock tune in my L29 gives me about 7* at similar throttle and rpm. No knock counts. I really need HPTuners so I can do the ‘411 pcm.
  13. JSlezak83

    Proportional Brake Controller

    I replaced a broken DrawTite brand in my truck with a Tekonsha P3. The gain on the Drawtite could not be adjusted down and would lock the trailer brakes. The P3 works nice and smooth and no longer has the jerky braking feel when slowing to a stop sign, ect. I wouldn’t tow with anything else again.
  14. JSlezak83

    CCLB dually #2

    My fan is the loudest part on the truck initially with the bus muffler. Once things start warming up and the fan frees up its super quiet. My half assed install with leaking band clamps at the muffler is probably louder than the noise actually coming from the tailpipe.
  15. JSlezak83

    How to: Install DIC in gmt400 overhead console

    Figured they were a resistor of some sort, but I’m not too savvy with electronics. I did note that that part of the board got quite warm after only a min or two of use. I’m guessing that’s why those cold soldered joints fail.
See more

Latest posts

Members online

... and 1 more.
Total: 1,593 (members: 51, guests: 1,542)

Forum statistics

Threads
64,247
Messages
1,389,789
Members
51,235
Latest member
ggddff

Share this page

Top