Recent content by Jglew82

  1. Jglew82

    Coil-overs: QA1 vs ALDAN

    They should be the same, but I'd give Aldan a call to verify it.
  2. Jglew82

    Coil-overs: QA1 vs ALDAN

    Yes, it is. The difference is with a coilover, the spring pressure is now on the T-Bar, not the LCA spring pocket, so if it's mounted below, those 2 bolts are holding the entire load. Factory shock has no spring pressure, therefore the bolts can support them. Always mount T-Bar of coilover on top.
  3. Jglew82

    Dorman hinge pins are garbage.

    Huh, that’s crazy. I was a bit skeptical about it being a GM part on Amazon, but sure enough it’s listed on gm parts websites. I, too, had never heard of these. Definitely interested in how they work out.
  4. Jglew82

    Dorman hinge pins are garbage.

    For real though, not fun to balance at all. Actually found a pic of my fuckery from a few years ago.
  5. Jglew82

    Dorman hinge pins are garbage.

    Do you have or know anyone with access to an engine hoist? I did mine with one and a ratchet strap.
  6. Jglew82

    Exhaust options for 6.0L swap

    Another 3”y pipe vote. I have long tubes on my 6.0 into a 3” Y, then into a SI DO 70 series Flowmaster.
  7. Jglew82

    Project Daily Driver

    Boogers or not, the thing that matters is if it's solid and doesn't leak. Looks like you did just that.
  8. Jglew82

    LS stuff

    No worries man, just saying that intake setup you have is pretty desirable, so you shouldn’t have a problem selling it. Is it cathedral port or square port?
  9. Jglew82

    LS stuff

    Also curious because that’s a gen 4 intake and TB with EV6 injectors, but a gen 3 pcm and harness with Multec injector connectors.
  10. Jglew82

    Recommend a easy install reliable remote start

    Been using this one for over 2 years trouble free. Great system, long range, lots of configurable options. https://www.amazon.com/dp/B00O2EGYDM/ref=cm_sw_r_cp_api_glt_fabc_DRAYRWD3VM8KN5BTSMR6?_encoding=UTF8&psc=1
  11. Jglew82

    $600 2000 C3500 CCLB

    Ha, mine still has scratches from when I cleaned my cylinder heads in it [emoji23].
  12. Jglew82

    Daily truck pics

    Lol, yeah the letter grilles on the HD’s make them look like methed up Colorados. The high country ones are marginally less terrible.
  13. Jglew82

    Coil-overs: QA1 vs ALDAN

    No worries man, looks pretty solid otherwise. I’d just be concerned with the mounting orientation for strength and longevity. You shouldn’t have a problem with alignment if you need to move it as long as your Z height stays the same.
  14. Jglew82

    Coil-overs: QA1 vs ALDAN

    Bottom pic is mine, mounted on top.
  15. Jglew82

    Coil-overs: QA1 vs ALDAN

    Not a criticism, but a question... aren’t you supposed to install the coil over T-bars on top of the control arms? That’s an awful lot of spring pressure on those mounting bolts. On mine, shown below, I ground off the welded nuts and mounted it topside with nuts and bolts.
Top