Hi,
I have an C3500 2WD single rear wheel truck
I'm looking at levelling the front and leaving the rear stock
Almost everything I see is for 4WD trucks
Has anyone levelled or done a small lift on there C3500? If so which products did you use?
Thanks
I have a Cheyenne Diesel with no cruise control or electric mirrors.
Is the wiring in place for either of these?
If so how can I add electric mirrors and cruise control?
Thanks
Hi,
My GMT400 is 1998 C3500 SRW 6.5TD, I'm pretty sure it's fitted with a GM 14 bolt with a 4.1:1 ratio.
Its currently has an open diff and I'm looking to fit a TrueTrac but there are three available for the 14 bolt.
1. How can I tell (ideally without pulling the rear end apart) if it is a...
Hi,
I have a C3500 lwb srw crew cab
The suspension is stock and I didn’t wanna fit a lift kit or raise the body unless I had to.
I have a set of Bushwacker Cut Out Flares, and as I’m due to get some painting done I don’t mind trimming the body & bumper.
I have some 16”x10” wheels to go on...
Does anyone produce a replacement high level brake light with integrated backup camera that fits our truck?
I have a backup camera mounted near the license plate which is great when reversing, but I'd like to switch to one mounted higher up for a rear view when driving along.
Hi, I have just driven my 6.5 and parked up for 20 mins. I just tried to restart, it cranked (as normal) but would not start.
It usually starts straight away. It's covered 90k miles and has the PMD relocated.
I noticed the 'wait to start' is going off quickly, is this because the engine is...
Hi,
I have some anchor points to fit in the stake pocket holes of my 8 foot bed.
As I have a be liner fitted, without removing it I have no idea where the holes are. Could anyone please post the measurements of where they are?
Many thanks