On my 99 burn it had the old school ONSTAR and cell phone. This would kill my battery in the winter. I removed the box that was located under the blower motor. No problems after I removed it. the dealerships installed these and mine was just wrapped on a splice.
**SOLVED**
Replaced the broken wire and the truck runs like a top now. Can't believe I missed that.
Must have been sitting on the manifold a while.
No stuttering and shifts well.
Thanks for the help!!!
So after some poking around the distributor and wires I found a the #1 wire resting on the manifold and arcing. When I picked it but is fell apart. So I'll replace the wire and see how it's goes. Also my check engine bulb seems to be gone it does not come on during bulb check or when pulling codes.
It's a new distributor but I was thinking of checking that again and wires. The truck sat most of the summer while I was replacing the interior so I've be checking some components that dont like to sit idle.
Toped off fluid it was a little low. I'm going to run it again to see if it needs more.
The fluid seemed to change the vibration as it seems as though it's coming on near 2000 rpm and not 200 at the time the dip stick read full so I didn't add anymore fluid.
Again no vibration in neutral or...
I'll check some of this this weekend. I might have been checking the trans fluid wrong. I've check it hot but not while running.
Hopefully it's that simple
D
Does not make the vibration in neutral or in park. There is slight vibration when at a stop In drive.
No check engine light in.
I'll check these they should be tight
Hello-
My 1995 k1500 has a bad vibration at around 2500+/- rpm. This happeneds under load at all speeds as long as I am on the throttle. All the following check out good:
U joints front and rear
Transmission and motor mounts
There was no play in the output shaft at the transfer case (np241c)...
Hello
I have a 1995 k1500 ext cab. 5.7l 4x4.
It is missing the purple o2 sensor wire. I've chased two purple wires from the fire wall but they appear to go to the fuse box.
Can someone tell me what wire it is at the firewall so I can run my own wire and not cut the wrong wire. Or if u have a...