Recent content by chris2323

  1. chris2323

    Parking Brake Cable Lengths *Updated*

    The 104” rear right cable was too long when i tried it on my 1997 k1500, extended cab, short bed, 10” brakes. The rear right for my truck is 96 1/2”. ACDELCO 18P1184
  2. chris2323

    4l60e 2-3 shift Please Help

    well, after my old transmission ruined 2 torque converter clutches, and broke the trans tailhousing, i decided to buy a new/remanufactured 4l60e. I installed new rubber engine and trans mounts. I also put new bearings and seals in my transfer case, and got a new driveshaft, slip yoke, and...
  3. chris2323

    Gauges not working

    Were you ever able to find out what was causing this? My speedo and tach are reading high also.
  4. chris2323

    Speedometer reading MUCH too high..

    Good to know. Thanks
  5. chris2323

    RPM and MPH Gauge Error

    My truck is a 97 Z71 k1500 5.7 l31, 4l60e 4x4, 411pcm, 360,000miles. First 2 clusters i tried came from 97 models with the same engine. One cluster was from a 95 v8. I checked my RPO codes in the glovebox and they line up with my current engine, trans, gear ratio. Ive had the vehicle for 10years...
  6. chris2323

    RPM and MPH Gauge Error

    Im starting to think i got some bad instrument panels from the salvage yard. Maybe i will try to find some replacement air core motors, or save up and go with dakota digital. Is there any way to test the air core motors, confirm they are bad?
  7. chris2323

    RPM and MPH Gauge Error

    Oem tire size and gear ratio. Everything reads correct in the scanner, instrument cluster is just off
  8. chris2323

    RPM and MPH Gauge Error

    I checked all my grounds and wiring with a multimeter/test light. Went through everything i could without pulling the enitre dash. Still haven’t found whats wrong. Maybe i got some bad instrument clusters? The 3 clusters ive tried all have over 200,000 miles
  9. chris2323

    RPM and MPH Gauge Error

    Which vss was it?
  10. chris2323

    RPM and MPH Gauge Error

    Ok yes thank you im going to look at the wiring diagram and check my grounds. I was just reading a bad ground can cause air core motors to read high
  11. chris2323

    Speedometer inaccuracies

    I was thinking i had a bad cluster/stepper motor as well. Both my rpm and mph are off. I tried 2 different instrument clusters from a salvage yard, and they both had the same error. Either i just got bad parts, or there is something else going on. I know my pcm is reporting the correct mph/rpm...
  12. chris2323

    Speedometer reading MUCH too high..

    My speedometer is off by the same amount. Havent been able to figure it out. I know its not a gear/tire issue because the correct speed is being reported by the pcm during a scan.
  13. chris2323

    Speedometer inaccuracies

    Did you ever figure out what was causing this? Im having the same problem as well except i dont have an abs light on
  14. chris2323

    RPM and MPH Gauge Error

    I have a 1997 K1500 pickup and both my rpm and mph gauges are not reading correctly. They are both reading higher than the actual rpm/mph, and seem to get farther off as rpm or speed increases. Has anyone had this issue? Any help or troubleshooting advice would be greatly appreciated. Rpm is...
    • chris2323
    • Thread
    • 411 gauge cluster instrument cluster k1500 mph rpm speed sensor vss wiring help
    • Replies: 21
    • Forum: Audio + Electronics
  15. chris2323

    Increasing Fuel Pressure on Spider Injectors

    I dont see how a slight pressure increase would really hurt anything on my NA engine. !!As long as the pcm tune is adjusted correctly!! My stock flow rate spider injectors are no where near capable of running with forced induction. If i had boost, i might be a little more worried about it. The...
See more

Latest posts

Members online

... and 4 more.
Total: 1,419 (members: 54, guests: 1,365)

Forum statistics

Threads
64,249
Messages
1,389,877
Members
51,243
Latest member
TruckinAnissa707

Share this page

Top