-
-
CI'd say late 70s, early 80s.
-
CChiefsonline replied to the thread Is it normal for 1995 TBI 5.7 k1500 to knock when timing set to 0?.My eyes are rolling lol. More fuel might equal less ping, but also can mean too rich and less power. Part throttle cruise might get...
-
CChiefsonline replied to the thread Good old school tools thread.I figured I’d dig out an old scan tool I had. Seems to work still.
-
-
COne thing to keep in mind is that once you near WOT your computer will drop out of min-emissions Closed Loop / Stoich mode and revert...
-
CIn order to give you an accurate answer for your specific truck, you would first have to gather the BLM (Block Learn Multiplier) numbers...
-
CChiefsonline replied to the thread 88 chevy power.
-
CYeah, the best I got was 14.5psi when the spring seat ran off the end of the adjuster screw. I backed it off to 14 so the seat was still...
-
CNever seen one listed.
-
CThe 94 - 95 7.4L used a 28LB Spring, running 26 - 32 PSI with smaller injectors. I've posted this from GearHead-EFI before but, for...
-
CChiefsonline replied to the thread 88 chevy power.Yes I do know that one for sure. Few years ago I run into that. Someone installed a new fuel pump AND a fuel pressure regulator kit...
-
CThey all had the same spring pressure, normally injector flow is based on 13PSI but, GM specs are 9 - 13. I don't think you'll be able...
-
CChiefsonline replied to the thread 88 chevy power.I’ve personally seen multiple weak fuel pumps on these trucks. They will keep running “ok” on some instances, but the power definitely...
-
CChiefsonline replied to the thread 88 chevy power.I swear I discovered a few years ago that for sure the 95 year had a stiffer spring that made 15 psi. Now I feel like I’m losing it lol.
-
CChiefsonline replied to the thread 88 chevy power.Personally I haven’t ever experimented with higher ratio rockers, but I have run short duration/high lift cams with success. Seat to...
-
CFirst stop is always a tune up. Plugs, wires, cap & rotor, fluids, fuel filter, check the fuel pressure. Then make sure everything is...
-
-
Loading…
-
Loading…
Members online
- DrMcBlarg
- ihaveatrucktodostuff
- 2dr95tahoe
- K496
- Awalter325
- Ztbrown1996
- Minn95Dually
- Outl4wAndy
- toolmakerson
- 1990_OBS_Rado
- kawiduckz
- 99xcss4
- Baastyler
- 99Yak
- ERS299
- Siopao
- 1998 K1500 Bubbles
- staabtown_hoodlum
- CrustyJunker
- Kenworthit13
- Nylo
- L31MaxExpress
- Noel11
- JR_101
- Austin52
- oefvet0708
- Just57
- jtc2389
- aksavanaman
- Feral peasant
- BNielsen
- Wademo
- fancyTBI
- Gmcred4x4
- Bignasty77
- ballsofstihl
- 99tan99
- 1972c20
- greeneyes
- Jdmoon
- Clone
- navyboy65
- Komet
- lucifer666
- BeardedGod86
- Schurkey
- cinch21
- Djeichenberg
- PS_94K1500
- Thatlowchevy