Mine is the same way as well. The truck has been wrecked before and have not been able to completely dial in my alignment so I’ll spend the extra money on it while it’s apart to rule it out. Otherwise, I’d leave it.
I am not sure what joints you’re referring to. There is the rag joint on the shaft that I will replace but as far as the drag link goes, it’s just the pitman arm coming off the box and the idler arm off the idler arm bracket on the frame.
I’m looking into replacing my steering box and want to know what y’all are running? I’m looking at the Borgeson box but am also open to the Redhead, Bluetooth and other reputable companies. I’m wondering how these boxes hold up compared to a junky reman and what y’all would recommend. For the...
Hondabond has my vote. It’s up there with the Toyota stuff. When used in appropriate applications, that stuff seals for a long time. It’s expensive ($18) but I always quote a tube in jobs that require it and have a good supply of it.
I’ve used it obviously on Hondas at work but also many Ford...
Fuel pressure has not been checked with a gauge but I’m assuming it’s ok as I have no long cranking when cold or hot. As far as the scan tool, we have Autel scanners and I am new to them. I learned on the Snap On Zeus and everything is in a different place on the Autel. I believe it is capable...
I’m troubleshooting a misfire on my 97 C1500 with the 350 Vortec 227K miles. I’ve got O2 sensor codes and a generic misfire code. I’m not wanting to throw parts at it but think it’s injector related but also running lean due to the fuel trim readings. Does anyone have any input to make sure I’m...
I’m an auto tech at an independent shop here in town. We get a lot of Chrysler products hence the photos.
First up are some push rods out of a 5.7 Hemi in a Charger. Belongs to a teenager. Say no more.
Next is the wonderful PepBoys alignment. Customer came in saying that their alignment was...
I’m going to end up learning my lesson with something like this. I tend to be lazy or too much in a hurry and never wear hearing pro and rarely eye pro. It’s usually safety squints for me.
I am open to building one on the side but the only problem is a lack of time. I may end up having to buy a whole unit. I’m mainly looking for good recommendations on parts and units as a whole.
Has anyone used the $1800 JEGS 4L60E?