Yes I have all were good except for 4 and 6. I had a vacuum leak on the intake gaskets and replaced them at the same time as my other truck. They were burning lean it looked like which makes sense. I got in contact with affordable fuel injection they told me my idle was to low. They sent me...
I will have to get my dad's scanner and I should be able to watch it. I have contacted them and I went through there diagnostics but none of it has pointed to an actual answer for my problem.
It is a internal pump. I ordered it as a 1990 chevy r3500 with a 350 for the tank and pump.
It is gm...
Hello all I bought a tbi kit from affordable fuel injection. It's on a 1975 chevy c30 with a 350. The tbi kit is basic and has no emissions controls on it. My question is why when I come to a stop it stalls out and dies (only sometimes out of no where. No sighns before it dies) I have replaced...
Sorry to be late on the reply I ended up using brake cleaner on the intake manifold gaskets and it was in the middle between 4 and 6 only under load. Replaced them and now it's good. Thank you
Hello all. Finally got my truck out for a 200 mile drive. Check engine light kept going on and off through out trip and finally stayed on coming home. Codes 42 44 45 popped up. 42 was from my new distributor install. 44 and 45 was o2 sensor to lean and to rich so I sprayed brake clean around the...
Hello all I have been working on a friend's 1990 chevy truck 5.7. He wanted to change the intake gaskets so he found a good used intake so I put it on and I didn't see that the coolant temp sensor hole near the thermostate has been plugged with a pipe fitting... I tried heating it really hot and...
Hello all I read through the posts about people who have done the swap and no one has asked what I am thinking. My truck is a 98 chevy 2wd 4l60e the previous owner swapped in a 350 it was a 305 originally. It runs fine but I want it to be right my question is will a computer from the same year...
Hello I wanted to know if anyone knows if a eclb 4x4 305 5 speed gets pretty decent mileage? Just asking to see if anyone dailys there's im looking to buy a really nice one thank you!
Hello everyone wanted to ask if anyone has swapped a vortec 350 distributor in a tbi 350. Not necessarily looking for a performance upgrade it's time for me to probably change the distributor and I like the way the vortec cap rotor and wires look. Thank you
Hello I have a 94 Chevy c1500 I was wondering how hard it is to do a power door lock swap. Right now I just have a power switch inside that locks the doors but no remote. Can those be programmed? Thank you
I have the long heavier direct drive starter. Reason I want the 96 is because it's smaller than mine spins off pretty good and only 50 bucks from a local parts store with a lifetime warranty.