-
-
yevgenievich replied to the thread 4l80E Intermittent No 4th Gear.Often could be a failure of tcc apply circuit or if vss giving bad information. Ecu will see slip with tcc applied and keep increasing... -
yevgenievich replied to the thread AC Blend door spline/tab broken.Was thinking of a different one. Might need to get the door it self
-
yevgenievich replied to the thread 2wd Spindle v Body Lift.Working on a vortec 454 with a body lift made it easier to access back of the intake. Otherwise everything is a bit further of a reach.
-
yevgenievich replied to the thread 1997 gmc k2500 burban.With shock bushing gone it was very obvious noise wise
-
yevgenievich replied to the thread 98 7.4 Vortec intake manifold leak.Also if there coolant showing up above the front passenger side intake bolts, it can be the heater hose seal. Oring in there can leak at...
-
yevgenievich replied to the thread Gen VI 7.4 411 swap-looking for intake.Idle Air control set up with the throttle body would need to be sorted, but there are a number of aftermarket intakes with injectors per...
-
yevgenievich replied to the thread Fuel tank Relocating.Can try the tahoe set up. But can also have one of the pipes cross over to the other side.
-
-
yevgenievich replied to the thread How does electronic timing advance work on a TBI distributor?.Coil trigger timing changes
-
yevgenievich replied to the thread Good motor mounts... how about this?.If I recall correctly, part numbers were not correct on 2wd set.
-
yevgenievich replied to the thread 99 shorty.Arteb headlights installed(euro light pattern). Need to aim still. My strategy on installing lights had been loosely mounting the base...
-
-
yevgenievich replied to the thread Number Plates.GMC-454
-
yevgenievich replied to the thread Led Headlights.The much brighter lights currently on the road cause softer light output from stock gmt400 very hard to see with when dark sections come...
-
-
yevgenievich replied to the thread Good motor mounts... how about this?.There is mislabel on 4x4 vs 2wd part numbers on energy suspension motor mounts
-
yevgenievich replied to the thread Good motor mounts... how about this?.It is on 4wd
-
-
Loading…
-
Loading…
