timberjacked
Newbie
Hi there,
After reading some of the forums I decided my maintenance approach of just throwing parts at my truck was probably not the best.
I downloaded TunerPro RT, bought the ALDL cable from Red Devil River, got what I think are the correct xdf and adx files for my ECM and tried to get connected to the vehicle.
Under Tools > Preferences > Data Acq./Emulation I selected my Standard Serial/COMM3 and tested for valid interface settings and got that the cable was 'found and functional', but the software hangs saying "DA: Connecting" in red on the bottom when I try to connect. Not sure what else to try!
Some info:
- 1993 k2500, 5.7L TBI w/ nv4500.
- ECM 16168625 (there was also a second sticker/barcode on there that said 16186735?)
- I used E6_TPV5_v250.xdf and A201_E6_v250.adx
Any hints/suggestions to get me rolling with datalogging?
Thanks in advance, this forum has been very helpful to lurk over the years and I hope someday to know enough to contribute!!
After reading some of the forums I decided my maintenance approach of just throwing parts at my truck was probably not the best.
I downloaded TunerPro RT, bought the ALDL cable from Red Devil River, got what I think are the correct xdf and adx files for my ECM and tried to get connected to the vehicle.
Under Tools > Preferences > Data Acq./Emulation I selected my Standard Serial/COMM3 and tested for valid interface settings and got that the cable was 'found and functional', but the software hangs saying "DA: Connecting" in red on the bottom when I try to connect. Not sure what else to try!
Some info:
- 1993 k2500, 5.7L TBI w/ nv4500.
- ECM 16168625 (there was also a second sticker/barcode on there that said 16186735?)
- I used E6_TPV5_v250.xdf and A201_E6_v250.adx
Any hints/suggestions to get me rolling with datalogging?
Thanks in advance, this forum has been very helpful to lurk over the years and I hope someday to know enough to contribute!!