Project

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Gsreeves

Newbie
Joined
Sep 11, 2020
Messages
6
Reaction score
12
Location
Ga
88 GMC Under the knife.
 

Attachments

  • 4A6F3F01-DC3A-4210-BBC1-FC88FADCB644.png
    4A6F3F01-DC3A-4210-BBC1-FC88FADCB644.png
    1.1 MB · Views: 52
  • AAA6229D-3257-4190-A4E6-2D332F550A38.jpeg
    AAA6229D-3257-4190-A4E6-2D332F550A38.jpeg
    335.3 KB · Views: 52
  • 22C240A7-D0F7-4B06-B378-16E5A342F09E.jpeg
    22C240A7-D0F7-4B06-B378-16E5A342F09E.jpeg
    315.5 KB · Views: 57
  • 5996B09D-CA55-4B4D-9C69-055F745D4683.jpeg
    5996B09D-CA55-4B4D-9C69-055F745D4683.jpeg
    252.7 KB · Views: 47

DonYukon

Dont stop until it sounds expensive
Joined
Aug 9, 2012
Messages
1,114
Reaction score
766
Location
Fayetteville NC
Are you talking about the heim joints on top of the rear end? If so those are rubber dust seals.
Yea Ive installed quite a few on my rig and others. where did you get them? I order my heim joint / rod ends same same lol from Barnes 4x4. but none of theirs come with dust boots . I assume yours are Teflon self lubricating?
 

Gsreeves

Newbie
Joined
Sep 11, 2020
Messages
6
Reaction score
12
Location
Ga
Yea Ive installed quite a few on my rig and others. where did you get them? I order my heim joint / rod ends same same lol from Barnes 4x4. but none of theirs come with dust boots . I assume yours are Teflon self lubricating?
These came from speedway motors.
You must be registered for see images attach
 

Gsreeves

Newbie
Joined
Sep 11, 2020
Messages
6
Reaction score
12
Location
Ga
Nice set up. I was thinking about doing this. Moving my tank to rear, and leave space for wider tire by bringing the links on the inside of the frame.
Cool man! We narrowed the rear end eight inches and welded in the four link kit. Now just wait for the coil-overs to show up.
 
Joined
May 8, 2017
Messages
3
Reaction score
3
Location
Fort Worth,TX
Cool man! We narrowed the rear end eight inches and welded in the four link kit. Now just wait for the coil-overs to show up.
I can't wait to see the finished product. My project will be on hold while I build up funds for it. Got a promotion and it will keep me busy for a while, but once I get back to thrashing I'll have the dough to get everything I'm needing, even upgrading my welder. Hopefully even kick in a nice plasma cutter for my garage.
 
Top