frito-bandito
8 Lugs + 6 Tires + 4 Doors
Finished bolting down the Tahoe rear seats this afternoon. It’s not too hard of a retrofit. The large seat on the driver side had one bolt hole that lined up, then I had to drill the rest. The smaller seat on the passenger side didn’t line up with any of the stock holes, so it took some measuring and drilling. I used grade 8 bolts with large fender washers to kinda spread the load out on the floor pan. I did have to use 2 short pieces of “1 square tubing as spacers for the two inner rear mounts. But now it’s pretty solid.
“Spacer” installed
The seats bolted down finally!!!
One of the “spacers” made from 1” tubing.
“Spacer” installed
You must be registered for see images attach
The seats bolted down finally!!!
You must be registered for see images attach
One of the “spacers” made from 1” tubing.
You must be registered for see images attach