It was not hard. I cut the bracket that holes it down. Those Tahoes (2002-2006) the bracket that the console is mounted to, bolts under the inner seat bolts. So you have to pull the seats to install the console. I just cut the bracket and did away with that. Where my 60-40 drivers seat bolted on the inner side, that was in the trans hump. So I used those bolts to bolt down the console bracket. I did have to make an extension bracket for the front hold down, and I only used the 2 forward bolts of the console. No big deal for me, I am a welder. I just finished making the next section where I will put a Chevelle horseshoe shifter, but the shifter will be a while before I install it. I also have some trim work left to get the 2 consoles to fit together better. The last pic, is the type of shifter I will use.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach