99burbK2500
I'm Awesome
wasn't trying to get that crazy cash wise. I originally just wanted to get the 4.8 going again and put a cam in. you see where that took me lolMay have been able to punch that bore out to a 5.7.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
wasn't trying to get that crazy cash wise. I originally just wanted to get the 4.8 going again and put a cam in. you see where that took me lolMay have been able to punch that bore out to a 5.7.
that did me a lot of good the first time lolI mean, since you was in there. . .
I did not mill the heads but am using a .040 compressed head gasket. stock is a .051. the average ls engine has a piston to deck of -.007, using that as a guide I have a new quench height of .033 and compression static compression ratio of 10.94:1. I am going to measure my piston to deck tho once I get my rings and the pistons in to confirm my true static compression ratio.Did you mill mill the heads? Flat top 5.3s without any trickery are 9.9:1 as I recall.
you aint kiddng lol if it doesn't work this time my wife said shes going to set it on fire!Apparently you're a sucker for punishment cuz you're goin for it again.
you aint kiddng lol if it doesn't work this time my wife said shes going to set it on fire!
you aint kiddng lol if it doesn't work this time my wife said shes going to set it on fire!