2WD Automatic Floor Shifter?

[NightRunner]

Here is mine, 16"Lokar. 95 RCSB W/T. Was NV3500, now 700R4. Still using the original boot.

You must be registered for see images attach

How was the install on this one? Tail/Floor mount? Linkage/Cable operated? This is EXACTLY what I'm looking for.

 

[PolarBear]

Here's the TCI shifter in the turbo truck.

You must be registered for see images attach

 

[86k10]

How was the install on this one? Tail/Floor mount? Linkage/Cable operated? This is EXACTLY what I'm looking for.

It's was tail mounted, linkage operated. I went that path since there was a hole there from the shifter. If I didn't have a hole on the floor board I might have gone with the floor mount.

Lokar ats6700bm is the number I used. I had to use the most rear position I could or the knob would hit the dash. I pivoted it forward. Looks good. I also used the back up switch kit.

 

[NightRunner]

It's was tail mounted, linkage operated. I went that path since there was a hole there from the shifter. If I didn't have a hole on the floor board I might have gone with the floor mount.

Lokar ats6700bm is the number I used. I had to use the most rear position I could or the knob would hit the dash. I pivoted it forward. Looks good. I also used the back up switch kit.

You're seriously the GOAT for this one. I've been worried about where a tail mount shifter would mount up in the cab of my truck but now I'm not so worried. I just want a shifter that's a breeze to install and I don't have to worry about linkages/cables not fitting or adjusting correctly lol

 

[Bardo]

You must be registered for see images attach

Not mine. Just a pic I saved because there's so much going on in this & so cleanly done.

I like how he has the newer door panels with the older Dash. Was thinking of doing this so I could add door speakers.