New Profile Posts

  1. Adair1
    Adair1 Lextech
    Hello Lextech. I have a 1998 GMC C1500 w/4.3l and 4l60e. I would like to convert this to the 0411 pcm. Do you have wiring schematics for this and if do could you email them to me? Also where is a good source for the pcm, connectors and pins? [email protected]
    Thank you for your time!!
  2. Rudi
    Rudi Lextech
    Hey i have a 96' Chevrolet suburban k1500 ,5,7L with the 4l60e and was hoping you could send me the pinout sheets for the 411 pcm. email me at [email protected]
  3. Guido
    Guido
    Better have it and don't need it than need it and don't have it
  4. Dylan Burow
    Dylan Burow
    Looking for 1988-1998 A.R.E. Fiberglass Tonneau for Sportside Trucks, Preferably in Wisconsin
  5. Mason Cramer
    Mason Cramer Lextech
    Hey Lextech. Just picked up a 411 PCM and wanting to do a swap on my '96 GMC K1500. 5.7L L31 and 4L60E. If you are still sending out pinout spreadsheets I'd love to get one! Thanks! My email is [email protected]
  6. Monkey Wrench
    Monkey Wrench
    I need some help the fresh air door on my 89 K2500 it’s hung open I disconnected the battery it didn’t work any ideas I can’t get to it
  7. Monkey Wrench
    Monkey Wrench
    “I’m a jack of all Trades and the master of a couple”
  8. bustedknuckles
    bustedknuckles delta_p
    Hello, I was re-reading a post on your lowering job.. i was wondering if you still like the stance or did you go any lower. I am interested in using the same wheel and tize combo you had and was wondering if you think they would live under a 4/6 drop? Thank you for your time.
    1. delta_p
      delta_p
      I am happy with the 2-4 drop. I think the 2-4 is a good compromise for handling, stance, and still carrying a bed load on occasion. There is about 3 1/4" from tire top to fender top in the front, and about 3 5/8" from tire top to fender top in the rear. The place where the wheel well trim is mounted on the fender. They don't tuck so it may be close on a 4/6.
      Jul 31, 2020
  9. JackE
    JackE evilunclegrimace
    Did you ever start a build thread on that old Suburban?
    1. evilunclegrimace
      evilunclegrimace
      No I have been DDing it every day. I have some pics of repairs that I have made. I am going to make a few changes soon and I will most likely put all of it together when I start the next mods.
      Jul 29, 2020
      JackE likes this.
  10. Rarered97
    Rarered97 5vortec7
    Hi there, are you able to make a harness for the stock fog light switch on my 00 Silverado 3500 obs? I've got the switch and pigtail.
    1. 5vortec7
      5vortec7
      Pm sent
      Aug 4, 2020 at 11:40 AM