WARNING: Viewer discretion is advised.

[deejaaa]

they look HD!

 

[Shiny]

You must be registered for see images attach

They should be bad ass!

You must be registered for see images attach

Now I have the balance removed.

 

[Supercharged111]

Those mounts are beefy enough to tear through the frame. Hell so are the stock hooks. My dually has a small tear way up front so reinforcing that area is one of the jillion projects I'll never get to. Something to keep in mind if you get that pig stuck.

 

[Shiny]

Definitely on my mind, I noticed there is a third hole behind the other two that I'm going to try to tie into.

 

[Shiny]

You must be registered for see images attach

Here's the brackets I made. I used 2x2 heavy wall square tubing, just like what is made into the Reese hitch receivers. Then I used some 1 inch thick bar stock to weld inside the square tube.

 

[Shiny]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

I removed my front skid plate and polished it. I took this skid plate off my 92 Z71 and then used it to replace the plastic one from this truck.

You must be registered for see images attach

 

[TylerZ281500]

badass clevis mounts, definitely need to get me some of them

 

[Z71Hobbs]

You must be registered for see images attach

Here's the brackets I made. I used 2x2 heavy wall square tubing, just like what is made into the Reese hitch receivers. Then I used some 1 inch thick bar stock to weld inside the square tube.

I might be interested in a set if you want to make a little cash. I've been toying around with something like this for a while.

 

[Cokeman95]

Ditto to what Z71Hobbs said. Would these work on a vehicle without a body lift?

Sent from my SAMSUNG-SM-G900A using Tapatalk

 

[Shiny]

I do not think they would fit. The frame is exposed on mine so that's how I was able to do it.