Turn signal harness/question

[Diego0123005]

My left turn signal one of the bulbs keeps loosing connection. The bulb is connected but the connector doesnt seem OEM and there are a pair of wires that have been seperated and want to know if those are the original ones where the connector is supposed to go. The bulb is fine its just the connector that needs replaced i think

You must be registered for see images attach

 

[kennythewelder]

Those orange wire nuts are not OE for sure. Wire nuts are for house hold wiring only. The wires need to be soldered and heat shrink needs to be used to seal this solder joint. You will want to do one wire at a time, and match the wires back to where you remove them. Most of the time this will be a brown wire for positive on the running lights. yellow for left turn , and green for right turn, and black should be the ground. Here is a video showing how to solder, and use heat shrink.

xc_hide_links_from_guests_guests_error_hide_media