the 1990 GMC Sierra DD

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

project 67 sub

I'm Awesome
Joined
Oct 19, 2013
Messages
361
Reaction score
36
Location
San Bernaghetto, Ca.
Well ****... Looks like it's time to put my other/better tach in now. Lol. And I was gonna change this one since was acting up anyways, so no big deal. (ended up just leaving it out and not putting the other one in it).
You must be registered for see images attach


New and better ball joint boots came in today. Now I can install my tubular control arms I've had for a while. Once I get a chance to work on my own stuff that is. (upper ball joint boot didnt fit, but the lower one did).
You must be registered for see images attach


Before... With ugly negative camber from hitting dips all crazy and stuff.
You must be registered for see images attach


During... Drivers side. Finally installing my tubular upper and lower control arms I've had for quite a while
You must be registered for see images attach


Passengers side
You must be registered for see images attach


After...
You must be registered for see images attach

You must be registered for see images attach


And outer tie rod ends replaced. Gotta do the inner tie rod ends in a few weeks
You must be registered for see images attach
 

project 67 sub

I'm Awesome
Joined
Oct 19, 2013
Messages
361
Reaction score
36
Location
San Bernaghetto, Ca.
No more nasty ass red carpet, and 50's aqua paint on the floor. As well as no more stereo and minimal other panels. Plan on eventually painting the dash gray, and and probably making my own door panels to get rid of these ugly red ones...
You must be registered for see images attach


Uhh... Weight reduction? Lol
You must be registered for see images attach


Getting their...
You must be registered for see images attach

You must be registered for see images attach


Damn... One last piece and I run out of paint. Almost made it though. Lol
You must be registered for see images attach


I guess because weight reduction after all. Lol
You must be registered for see images attach


Plasti-dip "tint" strip to go with it? Sure why not.
You must be registered for see images attach


Well since its raining, guess I'll hit and modify my heater/a.c. control switch housing to mount the switches for my lights in it
You must be registered for see images attach


Epoxying on some ABS plastic so I have something to mount my switches too.
You must be registered for see images attach


Almost their...
You must be registered for see images attach


And it's starting to go back in now
You must be registered for see images attach


Switch panel for lights done and installed
You must be registered for see images attach


Dash all back together. Some of it came out slightly darker than the majority of it, but it's good enough and looks a lot better than before... Now I just need to get rid of the rest of the red. Lol
You must be registered for see images attach
 
Top